[PATCH 00/18] arm: k3-am64: Add initial support for AM64 SK

Tom Rini trini at konsulko.com
Fri May 7 20:18:25 CEST 2021


On Thu, May 06, 2021 at 04:44:47PM +0530, Lokesh Vutla wrote:

> AM642 StarterKit (SK) board is a low cost, small form factor board
> designed for TI’s AM642 SoC. It supports the following interfaces:
> * 2 GB LPDDR4 RAM
> * x2 Gigabit Ethernet interfaces capable of working in switch and MAC mode
> * x1 USB 3.0 Type-A port
> * x1 UHS-1 capable µSD card slot
> * 2.4/5 GHz WLAN + Bluetooth 4.2 through WL1837
> * 512 Mbit OSPI flash
> * x2 UART through UART-USB bridge
> * XDS110 for onboard JTAG debug using USB
> * Temperature sensors, user push buttons and LEDs
> * 40-pin Raspberry Pi compatible GPIO header
> * 24-pin header for peripherals in MCU island (I2C, UART, SPI, IO)
> * 54-pin header for Programmable Realtime Unit (PRU) IO pins
> * Interface for remote automation. Includes:
> 	* power measurement and reset control
> 	* boot mode change
> 
> This series adds support for:
> - AM64 SoC detection
> - AM64 board detection
> - AM64 SK initial support
> - Re-use EVM defconfigs for SK.

All seems fine to me, thanks!

-- 
Tom
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 659 bytes
Desc: not available
URL: <https://lists.denx.de/pipermail/u-boot/attachments/20210507/736ec4a4/attachment.sig>


More information about the U-Boot mailing list