[PATCH 00/18] arm: k3-am64: Add initial support for AM64 SK

[Lokesh Vutla]

On 06/05/21 4:44 pm, Lokesh Vutla wrote:
> AM642 StarterKit (SK) board is a low cost, small form factor board
> designed for TI’s AM642 SoC. It supports the following interfaces:
> * 2 GB LPDDR4 RAM
> * x2 Gigabit Ethernet interfaces capable of working in switch and MAC mode
> * x1 USB 3.0 Type-A port
> * x1 UHS-1 capable µSD card slot
> * 2.4/5 GHz WLAN + Bluetooth 4.2 through WL1837
> * 512 Mbit OSPI flash
> * x2 UART through UART-USB bridge
> * XDS110 for onboard JTAG debug using USB
> * Temperature sensors, user push buttons and LEDs
> * 40-pin Raspberry Pi compatible GPIO header
> * 24-pin header for peripherals in MCU island (I2C, UART, SPI, IO)
> * 54-pin header for Programmable Realtime Unit (PRU) IO pins
> * Interface for remote automation. Includes:
> 	* power measurement and reset control
> 	* boot mode change
> 
> This series adds support for:
> - AM64 SoC detection
> - AM64 board detection
> - AM64 SK initial support
> - Re-use EVM defconfigs for SK.
> 
> This series depends on the following series:
> - https://patchwork.ozlabs.org/user/todo/uboot/?series=240546
> - https://patchwork.ozlabs.org/user/todo/uboot/?series=241946
> - https://patchwork.ozlabs.org/user/todo/uboot/?series=242110

Fixed the timer clock frequency locally and applied to u-boot-ti/for-rc

Thanks and regards,
Lokesh