[PATCH v2 2/2] board: mntre: imx8mq: Add MNT Reform 2 board support

[Patrick Wildt]

Am Fri, Sep 03, 2021 at 08:25:39PM +0200 schrieb Heiko Thiery:
> Hi Patrick,
> 
> Am Fr., 3. Sept. 2021 um 16:30 Uhr schrieb Patrick Wildt <patrick at blueri.se>:
> >
> > Am Fri, Sep 03, 2021 at 11:01:06AM +0200 schrieb Heiko Thiery:
> > > Hi Patrick,
> > >
> > > Am Do., 2. Sept. 2021 um 23:44 Uhr schrieb Patrick Wildt <patrick at blueri.se>:
> > > >
> > > > The MNT Reform 2 is a modular DIY laptop.  In its initial version it
> > > > is based on the BoundaryDevices i.MX8MQ SoM.  Some parts have been
> > > > lifted from BoundaryDevices official U-Boot downstream project.
> > > >
> > > > Signed-off-by: Patrick Wildt <patrick at blueri.se>
> > >
> > > I just sent a patch to add board support for the Kontron pitx-imx8m
> > > that is also based on the imx8mq SOC. I already switched the flash.bin
> > > generation to binman. Maybe you can use this patchset as a template
> > > and also switch to binman for that board.
> > >
> > > --
> > > Heiko
> >
> > Hi Heiko,
> >
> > I think that's a good idea.  But I seem to be having issues:
> >
> > U-Boot SPL 2021.10-rc3-00023-g2c634e01b6-dirty (Sep 03 2021 - 18:22:04 +0200)
> > Normal Boot
> > Could not get FIT buffer of 686592 bytes
> >         check CONFIG_SYS_SPL_MALLOC_SIZE
> 
> I'm not sure, but could you check that no old fragments are left in
> the output folder before building the flash.bin with binman. I can
> remember that I had also some strange issues while switching to
> binman.

No change.  Is your u-boot.itb that much smaller?

-rw-r--r--  1 patrick  patrick   670K Sep  4 00:50 imx8mq_reform2/u-boot.itb