[PATCH] arm: dts: armada8040: Fix CP0 eMMC/SDIO support

[Stefan Roese]

On 27.09.21 23:03, Robert Marko wrote:
> During the migration to a single DTSI for the CP110-s specific pinctrl
> compatibles were moved to the SoC DTSI as CP0 and CP1 have some specifics.
> Namely, CP0 eMMC/SDIO support depends on the mvebu-pinctrl driver setting
> the BIT(0) in eMMC PHY IO Control 0 Register to 0 in order for the connect
> the eMMC/SDIO PHY to the controller and not use it as a MPP pin multiplexor.
> 
> So, the mvebu-pinctrl driver check specifically for the
> "marvell,armada-8k-cpm-pinctrl" compatible to clear the that bit.
> 
> Issue is that compatibles in the 8040 DTSI were set to "marvell,8k-cpm-pinctrl"
> for CP0 and "marvell,8k-cps-pinctrl" for the CP1.
> This is obviously incorrect as the pinctrl driver does not know about these.
> 
> So fix the regression by applying correct compatibles to the DTSI.
> Regression found and tested on the Puzzle M801 board.
> 
> Fixes: a0ba97e5 ("arm: armada: dts: Use a single dtsi for cp110 die description")
> Signed-off-by: Robert Marko <robert.marko at sartura.hr>

Applied to u-boot-marvell/master

Thanks,
Stefan

> ---
>   arch/arm/dts/armada-8040.dtsi | 4 ++--
>   1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/dts/armada-8040.dtsi b/arch/arm/dts/armada-8040.dtsi
> index 5123742b8d..eec5fa2774 100644
> --- a/arch/arm/dts/armada-8040.dtsi
> +++ b/arch/arm/dts/armada-8040.dtsi
> @@ -40,7 +40,7 @@
>   };
>   
>   &cp0_pinctl {
> -	compatible = "marvell,mvebu-pinctrl", "marvell,8k-cpm-pinctrl";
> +	compatible = "marvell,mvebu-pinctrl", "marvell,armada-8k-cpm-pinctrl";
>   	bank-name ="cp0-110";
>   
>   	cp0_i2c0_pins: cp0-i2c-pins-0 {
> @@ -75,7 +75,7 @@
>   };
>   
>   &cp1_pinctl {
> -	compatible = "marvell,mvebu-pinctrl", "marvell,8k-cps-pinctrl";
> +	compatible = "marvell,mvebu-pinctrl", "marvell,armada-8k-cps-pinctrl";
>   	bank-name ="cp1-110";
>   
>   	cp1_ge1_rgmii_pins: cp1-ge-rgmii-pins-0 {
> 


Viele Grüße,
Stefan

-- 
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: sr at denx.de