[RFC PATCH 2/3] mx6: ddr: Wait before issuing the first MRS cmd

[Francesco Dolcini]

Wait 1ms before issuing the first MRS command to write DDR3 Mode
registers.

There is a requirement to wait minimum of Reset CKE Exit time, tXPR,
with tXPR = max(tXS, 5tCK) and to wait 500 useconds after reset is
de-asserted. It seems that for some reason this is not enforced by the
MMDC controller, despite MMDCx_MDOR RST_to_CKE and tXPR being correctly
configured.

Without this change we experienced random memory initialization failures
with about 2% boot failure rate on specific problematic boards, after
this change we were able to do more than 10.000 power-cycle without a
single failure.

Fixes: fe0f7f7842e1 ("mx6: add mmdc configuration for MX6Q/MX6DL")
Signed-off-by: Francesco Dolcini <francesco.dolcini at toradex.com>
---
 arch/arm/mach-imx/mx6/ddr.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm/mach-imx/mx6/ddr.c b/arch/arm/mach-imx/mx6/ddr.c
index 08e2f0f130a6..7b3d620094c4 100644
--- a/arch/arm/mach-imx/mx6/ddr.c
+++ b/arch/arm/mach-imx/mx6/ddr.c
@@ -1526,6 +1526,8 @@ void mx6_ddr3_cfg(const struct mx6_ddr_sysinfo *sysinfo,
 			((sysinfo->ncs == 2) ? 1 : 0) << 30; /* SDE_1 for CS1 */
 
 	/* Step 8: Write Mode Registers to Init DDR3 devices */
+	mdelay(1); /* Wait before issuing the first MRS command
+		      (tXPR / 500us CKE delay after reset deassertion) */
 	for (cs = 0; cs < sysinfo->ncs; cs++) {
 		/* MR2 */
 		val = (sysinfo->rtt_wr & 3) << 9 | (ddr3_cfg->SRT & 1) << 7 |
-- 
2.25.1