[PATCH] spl: spl_sdp: don't call board_usb_init twice

Angus Ainslie angus at akkea.ca
Wed Apr 20 20:27:16 CEST 2022


Hi

On 2022-01-17 06:11, Angus Ainslie wrote:
> When CONFIG_DM_USB is not defined then usb_gadget_initialize is just a 
> call
> to board_usb_init. Calling board_usb_init twice causes the USB to fail 
> so
> make sure the second invocation is not compiled in when CONFIG_DM_USB 
> is
> not defined.
> 
> Signed-off-by: Angus Ainslie <angus at akkea.ca>
> ---
>  common/spl/spl_sdp.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/common/spl/spl_sdp.c b/common/spl/spl_sdp.c
> index ae9c09883a..2a2bc8475d 100644
> --- a/common/spl/spl_sdp.c
> +++ b/common/spl/spl_sdp.c
> @@ -17,7 +17,8 @@ static int spl_sdp_load_image(struct spl_image_info
> *spl_image,
>  	int ret;
>  	const int controller_index = CONFIG_SPL_SDP_USB_DEV;
> 
> -	usb_gadget_initialize(controller_index);
> +	if (IS_ENABLED(CONFIG_DM_USB))
> +		usb_gadget_initialize(controller_index);
> 
>  	board_usb_init(0, USB_INIT_DEVICE);

Any comments on this patch ?

Thanks
Angus



More information about the U-Boot mailing list