IMX8MM board with 512MB

Tim Harvey tharvey at
Fri Feb 4 23:14:59 CET 2022


I've got an IMX8MM board that I'm trying to add support for which has
512MB of LPDDR4 DRAM. I've run through the NXP dram calibration and
stress test fine and added the dram config from the NXP tool into
U-Boot but I'm finding the board is hanging somewhere in the SPL
(after dram_init but likely where/when the SPL starts using DRAM).

Is there any reason I should be having difficulty with an IMX8MM with
less than 1GiB of DRAM? All the boards I see support for are 1, 2, 3,
or 4GiB.

Best regards,


More information about the U-Boot mailing list