[PATCH 4/7] usb: ehci-omap: Make Kconfig select PHY if USB_EHCI_OMAP

[Adam Ford]

The USB_EHCI_OMAP driver currently has a series of Kconfig options
which let users specify a GPIO for the reset pin.  Some devices
may have only one reset, while others might have more.

Since there is a nop phy driver, let's selct enable the PHY
system, and imply the nop phy driver.  The nop phy driver can now
toggle the reset pins when putting the phy in and out of reset.

If the gpio is listed under the phy, it will get toggled and
the hard-coded config options specifying the GPIO numbers can
eventually go away.

Signed-off-by: Adam Ford <aford173 at gmail.com>
---
 drivers/usb/host/Kconfig | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index 7743c962cf..f0fb66abad 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -191,6 +191,8 @@ config USB_EHCI_MXS
 config USB_EHCI_OMAP
 	bool "Support for OMAP3+ on-chip EHCI USB controller"
 	depends on ARCH_OMAP2PLUS
+	select PHY
+	imply NOP_PHY
 	default y
 	---help---
 	  Enables support for the on-chip EHCI controller on OMAP3 and later
-- 
2.32.0