[PATCH 2/4] firmware: zynqmp: Move loading message to debug

[Michal Simek]

Power domain driver is using this function for every IP which is PD listed.
This can end up with a lot of messages which end up in boot log. That's why
show it only in EL3 as was used in past.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

 drivers/firmware/firmware-zynqmp.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/firmware/firmware-zynqmp.c b/drivers/firmware/firmware-zynqmp.c
index 10240ddccd3b..d6dd5a394ee9 100644
--- a/drivers/firmware/firmware-zynqmp.c
+++ b/drivers/firmware/firmware-zynqmp.c
@@ -131,7 +131,8 @@ void zynqmp_pmufw_load_config_object(const void *cfg_obj, size_t size)
 	int err;
 	u32 ret_payload[PAYLOAD_ARG_CNT];
 
-	printf("Loading new PMUFW cfg obj (%ld bytes)\n", size);
+	if (IS_ENABLED(CONFIG_SPL_BUILD))
+		printf("Loading new PMUFW cfg obj (%ld bytes)\n", size);
 
 	flush_dcache_range((ulong)cfg_obj, (ulong)(cfg_obj + size));
 
-- 
2.34.1