[PATCH] xilinx: common: change bootm_size to not go beyond ram_top

[Ricardo Salveti]

On Thu, Jan 20, 2022 at 4:33 AM Michal Simek <monstr at monstr.eu> wrote:
> On 1/19/22 23:52, Ricardo Salveti wrote:
> > The available ram can be limited by ram_top as that depends on the
> > reserved memory nodes provided by the device-tree (via
> > board_get_usable_ram_top), so make sure to respect ram_top when setting
> > up bootm_size to avoid overlapping reserved memory regions (e.g. memory
> > used by OP-TEE).
> >
> > The same logic is available in env_get_bootm_size when bootm_size is
> > not defined by the default environment.
> >
> > Signed-off-by: Ricardo Salveti <ricardo at foundries.io>
> > ---
> >   board/xilinx/common/board.c | 3 +++
> >   1 file changed, 3 insertions(+)
> >
> > diff --git a/board/xilinx/common/board.c b/board/xilinx/common/board.c
> > index 78a5d0efa86..4928fab2c96 100644
> > --- a/board/xilinx/common/board.c
> > +++ b/board/xilinx/common/board.c
> > @@ -389,6 +389,9 @@ int board_late_init_xilinx(void)
> >       if (CONFIG_IS_ENABLED(ARCH_ZYNQ) || CONFIG_IS_ENABLED(MICROBLAZE))
> >               bootm_size = min(bootm_size, (phys_size_t)(SZ_512M + SZ_256M));
> >
> > +     if (gd->ram_base + bootm_size > gd->ram_top)
> > +             bootm_size = gd->ram_top - gd->ram_base;
> > +
> >       ret |= env_set_hex("script_offset_f", CONFIG_BOOT_SCRIPT_OFFSET);
> >
> >       ret |= env_set_addr("bootm_low", (void *)gd->ram_base);
>
> Isn't it easier to directly setup bootm_size like this?
>
> phys_size_t bootm_size = gd->ram_top - gd->ram_base;

Yup, that should work better, will send a v2.

Thanks,
-- 
Ricardo Salveti