[PATCH] arm: kirkwood: Pogoplug V4 : Use Marvel network PHY driver

[Tony Dinh]

The Pogoplug V4 board has the network chip Marvell 88E1118R. So to
properly configure the network, enable CONFIG_PHY_MARVELL to activate
the driver M88E1118R.

- This patch depends on the series:
https://patchwork.ozlabs.org/project/uboot/patch/20220124061712.28316-2-mibodhi@gmail.com/

Signed-off-by: Tony Dinh <mibodhi at gmail.com>
---

 configs/pogo_v4_defconfig | 1 +
 1 file changed, 1 insertion(+)

diff --git a/configs/pogo_v4_defconfig b/configs/pogo_v4_defconfig
index 5490067b9e..1cf409c834 100644
--- a/configs/pogo_v4_defconfig
+++ b/configs/pogo_v4_defconfig
@@ -62,6 +62,7 @@ CONFIG_KIRKWOOD_GPIO=y
 CONFIG_MVEBU_MMC=y
 CONFIG_MTD=y
 CONFIG_MTD_RAW_NAND=y
+CONFIG_PHY_MARVELL=y
 CONFIG_DM_ETH=y
 CONFIG_MVGBE=y
 CONFIG_MII=y
-- 
2.30.2