[v4 12/12] spi: aspeed: Fix bug when SPI_NOR_4B_OPCODES flag is set

Cédric Le Goater clg at kaod.org
Fri Jul 1 11:44:43 CEST 2022


On 5/24/22 07:56, Chin-Ting Kuo wrote:
> When SPI_NOR_4B_OPCODES flag is set for a specific flash
> in spi_nor_ids[] table, EN4B command will not be issued and
> 4-byte dedicated commands will be used to access SPI flash.
> Thus, instead of EN4B command, address length is more suitable
> for deciding whether the controller should be set to 4-byte mode.
> 
> Signed-off-by: Chin-Ting Kuo <chin-ting_kuo at aspeedtech.com>
> ---
>   drivers/spi/spi-aspeed.c | 7 +++----
>   1 file changed, 3 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/spi/spi-aspeed.c b/drivers/spi/spi-aspeed.c
> index e5e348eb7b..687ddc370b 100644
> --- a/drivers/spi/spi-aspeed.c
> +++ b/drivers/spi/spi-aspeed.c
> @@ -504,10 +504,6 @@ static int aspeed_spi_exec_op_user_mode(struct spi_slave *slave,
>   	/* Restore controller setting. */
>   	writel(flash->ce_ctrl_read, ctrl_reg);
>   
> -	/* Set controller to 4-byte mode when flash is in 4-byte mode. */
> -	if (op->cmd.opcode == SPINOR_OP_EN4B)
> -		priv->info->set_4byte(bus, cs);
> -
>   	return 0;
>   }


This should be part of the patch adding the driver.

Thanks,

C.


> @@ -561,6 +557,9 @@ static int aspeed_spi_dirmap_create(struct spi_mem_dirmap_desc *desc)
>   		       plat->ctrl_base + REG_CE0_CTRL_REG + cs * 4);
>   		priv->flashes[cs].ce_ctrl_read = reg_val;
>   
> +		if (op_tmpl.addr.nbytes == 4)
> +			priv->info->set_4byte(bus, cs);
> +
>   		dev_dbg(dev, "read bus width: %d [0x%08x]\n",
>   			op_tmpl.data.buswidth, priv->flashes[cs].ce_ctrl_read);
>   	} else {



More information about the U-Boot mailing list