[PATCH] arm: dts: stm32mp1: Drop fastboot and stm32prog trigger gpios on DHCOM

[Patrick DELAUNAY]

Hi,

On 6/30/22 16:19, Johann Neuhauser wrote:
> PA13 and PA14 are used for USB power control and can't be used
> to enforce fastboot or stm32prog mode by pressing a button.
>
> Defining CONFIG_FASTBOOT/CONFIG_CMD_STM32PROG without this patch applied
> results in fastboot/stm32prog always starting, because PA13/PA14 are always
> low during boot. So drop the wrong trigger gpios definitions.
>
> Signed-off-by: Johann Neuhauser <jneuhauser at dh-electronics.com>
>
> ---
>
>   arch/arm/dts/stm32mp15xx-dhcom-u-boot.dtsi | 2 --
>   1 file changed, 2 deletions(-)
>
> diff --git a/arch/arm/dts/stm32mp15xx-dhcom-u-boot.dtsi b/arch/arm/dts/stm32mp15xx-dhcom-u-boot.dtsi
> index d73967ac1b5d..ee747a52bb7c 100644
> --- a/arch/arm/dts/stm32mp15xx-dhcom-u-boot.dtsi
> +++ b/arch/arm/dts/stm32mp15xx-dhcom-u-boot.dtsi
> @@ -27,8 +27,6 @@
>   	config {
>   		u-boot,boot-led = "heartbeat";
>   		u-boot,error-led = "error";
> -		st,fastboot-gpios = <&gpioa 13 GPIO_ACTIVE_LOW>;
> -		st,stm32prog-gpios = <&gpioa 14 GPIO_ACTIVE_LOW>;
>   		dh,som-coding-gpios = <&gpiof 12 0>, <&gpiof 13 0>, <&gpiof 15 0>;
>   		dh,ddr3-coding-gpios = <&gpioz 6 0>, <&gpioz 7 0>;
>   	};


The support of these buttons GPIO A13 and A14 have be done for ST boards 
EVx and DKx;

it is an internal request for Android support on top of OpenSTLinux.

and make no sense on DHCOM STM32MP15

     USB_PWR_STAT USB Host over current indicator (active low) 174 I PA14 -
     USB_PWR_EN USB Host power enable signal (active low) 176 O PA13 -

moreover, if you never use these properies "st,fastboot-gpios" and 
"st,stm32prog-gpios" on DH boards,

you can also clean the code in board/dhelectronics/dh_stm32mp1/board.c, 
board_key_check() can be removed.

=> it is called board_init()


This code was initially copied from 'board/st/stm32mp1/stm32mp1.c'

but after your patch I think it is not needed.


Anyway for this device tree patch


Reviewed-by: Patrick Delaunay <patrick.delaunay at foss.st.com>

Thanks
Patrick