[PATCH v6 5/7] configs: imx8mm: Define CONFIG_SYS_UBOOT_BASE for i.MX8m

[sbabic at denx.de]

> The macro `CONFIG_SYS_UBOOT_BASE` is used by SPL loaders `"NOR"` and
> `"XIP"` to determine the base address of u-boot.
> For `"NOR"` on i.MX8MM it is the base address of QSPI0 plus the offset
> of the flattened image tree blob.
> Although `QSPI0_AMBA_BASE` is used to define CONFIG_SYS_UBOOT_BASE in
> multiple board header files for i.MX8MM, it is not specified.
> Specify offset of flattened image tree blob (needs to be set to same
> value as specified in 'binman' node), base address of QSPI0 and size of
> FlexSPI configuration block.
> Signed-off-by: Mamta Shukla <mamta.shukla at leica-geosystems.com>
> Signed-off-by: Thomas Haemmerle <thomas.haemmerle at leica-geosystems.com>
> Tested-by: Adam Ford <aford173 at gmail.com>
> Reviewed-by: Fabio Estevam <festevam at denx.de>
> Reviewed-by: Andrey Zhizhikin  <andrey.zhizhikin at leica-geosystems.com>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================