Pull request: u-boot-imx u-boot-imx-20220726

[Fabio Estevam]

[Adding Josua]

On Tue, Jul 26, 2022 at 3:12 PM Tom Rini <trini at konsulko.com> wrote:

> So, funny issue here now.  With:
> commit d0399a46e7cda63c07e3eb8558bef84cfb068028
> Author: Marcel Ziswiler <marcel.ziswiler at toradex.com>
> Date:   Thu Jul 21 15:27:26 2022 +0200
>
>     imx6dl/imx6qdl: synchronise device trees with linux
>
>     Synchronise device trees with linux-next next-20220708.
>
>     Signed-off-by: Marcel Ziswiler <marcel.ziswiler at toradex.com>
>
> This breaks ethernet on my mx6cuboxi board, which in reality is an MX6
> Hummingboard.  I think this means that we need some further tweak in the
> board.c file, given the past history I recall of "oops, ethernet broke
> again" here.  Since I don't want to block everything else and after
> re-reading that commit, I don't think this is some systemic breakage but
> more likely board specific, I have applied the PR.  I am hopeful that we
> can resolve this issue fairly quickly.

The sync with imx6 upstream  DT undoes some of the changes from:

commit 17baba4682001cc11446ff8406c63850b46edf72
Author: Josua Mayer <josua at solid-run.com>
Date:   Thu May 19 12:31:58 2022 +0300

    ARM: dts: imx6qdl-sr-som: add support for alternate phy addresses

    The Cubox has an unstable phy address - which can appear at either
    address 0 (intended) or 4 (unintended).

    SoM revision 1.9 has replaced the ar8035 phy with an adin1300, which
    will always appear at address 1.

    Change the reg property of the phy node to the magic value 0xffffffff,
    which indicates to the generic phy driver that all addresses should be
    probed. That allows the same node (which is pinned by phy-handle) to match
    either the AR8035 PHY at both possible addresses, as well as the new one
    at address 1.
    Also add the new adi,phy-output-clock property for enabling the 125MHz
    clock used by the fec ethernet controller, as submitted to Linux [1].

    Linux solves this problem differently:
    For the ar8035 phy it will probe both phy nodes in device-tree in order,
    and use the one that succeeds. For the new adin1300 it expects U-Boot to
    patch the status field in the DTB before booting

    While at it also sync the reset-delay with the upstream Linux dtb.

    [1] https://patchwork.kernel.org/project/netdevbpf/patch/20220428082848.12191-4-josua@solid-run.com/

    Signed-off-by: Josua Mayer <josua at solid-run.com>

Josua, could you please take a look?