[PATCH] mvebu: pinctrl: apply SDHCI PHY config for A7K

[Stefan Roese]

On 25.07.22 14:13, Pali Rohár wrote:
> From: Konstantin Porotchkin <kostap at marvell.com>
> 
> Current pin control driver applies SDHCI PHY MUX selection
> when board DT calls for eMMC function on MPP wires.
> However, for CP side eMMC, only the "armada-8k-cpm-pinctrl"
> compatibility string is taken into account, which causes
> CP-SDHCI on Armada-7K boards to fail.
> This patch adds "armada-7k-pinctrl" compatibility string
> handling for the CP-SDHCI PHY configuration case.
> 
> Signed-off-by: Konstantin Porotchkin <kostap at marvell.com>
> Reviewed-by: Igal Liberman <igall at marvell.com>

Reviewed-by: Stefan Roese <sr at denx.de>

Thanks,
Stefan

> ---
>   drivers/pinctrl/mvebu/pinctrl-mvebu.c | 4 +++-
>   1 file changed, 3 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/pinctrl/mvebu/pinctrl-mvebu.c b/drivers/pinctrl/mvebu/pinctrl-mvebu.c
> index 536c6aff96e5..fd49a97b5b0a 100644
> --- a/drivers/pinctrl/mvebu/pinctrl-mvebu.c
> +++ b/drivers/pinctrl/mvebu/pinctrl-mvebu.c
> @@ -52,7 +52,9 @@ void mvebu_pinctl_emmc_set_mux(struct udevice *dev, u32 pin, u32 func)
>   				     EMMC_PHY_CTRL_SDPHY_EN);
>   		}
>   	} else if (!fdt_node_check_compatible(blob, node,
> -					"marvell,armada-8k-cpm-pinctrl")) {
> +					"marvell,armada-8k-cpm-pinctrl") ||
> +		   !fdt_node_check_compatible(blob, node,
> +					"marvell,armada-7k-pinctrl")) {
>   		if ((pin == CP110_EMMC_CLK_PIN_ID) &&
>   		    (func == CP110_EMMC_CLK_FUNC)) {
>   			clrbits_le32(priv->base_reg + CP_EMMC_PHY_CTRL_REG,

Viele Grüße,
Stefan Roese

-- 
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: sr at denx.de