[PATCH 0/4] mmc: zynq_sdhci: Add support for dynamic IP configuration

[Michal Simek]

st 23. 2. 2022 v 15:36 odesílatel Michal Simek <michal.simek at xilinx.com> napsal:
>
> Hi,
>
> with SOM boards low level sdhci setting is not fully done. There are
> additional registers which are normally programmed via psu_init() but in
> this case they are not initialized. Information can be taken from DT and
> via firmware interface that values can be setup and that's exactly what
> this series is doing.
>
> Thanks,
> Michal
>
>
> Ashok Reddy Soma (4):
>   firmware: zynqmp: Add and update firmware enums
>   firmware: zynqmp: Add support for set sd config and is function
>     supported
>   lib: div64: Add support for round up of div64_u64
>   mmc: zynq_sdhci: Add support for dynamic configuration
>
>  drivers/firmware/firmware-zynqmp.c |  51 +++++++++++++++
>  drivers/mmc/zynq_sdhci.c           | 101 ++++++++++++++++++++++++++++-
>  include/linux/math64.h             |   3 +
>  include/zynqmp_firmware.h          |  29 +++++++++
>  4 files changed, 182 insertions(+), 2 deletions(-)
>
> --
> 2.35.1
>

Applied.
M

-- 
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Xilinx Microblaze
Maintainer of Linux kernel - Xilinx Zynq ARM and ZynqMP ARM64 SoCs
U-Boot custodian - Xilinx Microblaze/Zynq/ZynqMP/Versal SoCs