[PATCH v1 00/11] rockchip fixes and extend rk3568 support

[Jagan Teki]

On Tue, Feb 22, 2022 at 7:02 AM Peter Geis <pgwipeout at gmail.com> wrote:
>
> to: Simon Glass <sjg at chromium.org>
> to: Philipp Tomsich <philipp.tomsich at vrull.eu>
> to: Kever Yang <kever.yang at rock-chips.com>
> to: Lukasz Majewski <lukma at denx.de>
> to: Sean Anderson <seanga2 at gmail.com>
> to: Peng Fan <peng.fan at nxp.com>
> to: Jaehoon Chung <jh80.chung at samsung.com>
> to: Heiko Stübner <heiko at sntech.de>
> cc: u-boot at lists.denx.de
>
> Good Evening,
>
> The following is a few patches for rockchip mainline u-boot support.
> Patches 1-3 are fixes for the rk3568 reset handler, rockchip emmc dma to
> sram, and building the rockchip-sfc driver.
> Patch 4 adds a sanity check for the minimum sfc frequency.
> Patch 5 and 6 add adc support to spl and enable the rockchip recovery
> handler in spl, before attempting to load u-boot.
> Patch 7 enables rk3568 spl bootrom device detection.
> Patch 8 enables automatic clock gating and other power saving features
> on rk3568, which solves the chip running hotter compared to downstream.
> Patch 9 and 10 move the dwc3 platform data to the chip specific code and
> enable dwc3 otg support on rk3568.
> Patch 11 is an RFC patch for fixing ram detection on rk3568. Downstream
> goes about this a different way, where they implemented a special
> library to handle this.
>
> Please review and *especially test* patch 11.
>
> Very Respectfully,
> Peter Geis
>
> Peter Geis (11):
>   clk: rockchip: rk3568: fix reset handler
>   mmc: sdhci: allow disabling sdma in spl
>   spi: rockchip-sfc: fix building rockchip-sfc
>   spi: rockchip-sfc: sanity check minimum freq
>   spl: support adc drivers in spl
>   rockchip: handle bootrom recovery mode in spl
>   rockchip: rk3568: add boot device detection
>   rockchip: rk3568: enable automatic clock gating
>   rockchip: move dwc3 config to chip specific handler
>   rockchip: rk3568: add dwc3 otg support
>   [RFC] rockchip: rk356x: attempt to fix ram detection

Better keep sending
1. drivers on respective mintainers. - and approve them
2. add rk3568 support as separate series by syncing Linux dts(i) from
a specific tag.

This way it is easier for maintainers to review it.

Thanks,
Jagan.