[PATCH v2] mmc: fsl_esdhc_imx: use VENDORSPEC_FRC_SDCLK_ON when necessary

[Jaehoon Chung]

On 3/10/22 01:10, Tom Rini wrote:
> On Tue, Feb 22, 2022 at 11:28:18AM +0800, haibo.chen at nxp.com wrote:
> 
>> From: Haibo Chen <haibo.chen at nxp.com>
>>
>> After commit f132aab40327 ("Revert "mmc: fsl_esdhc_imx: use
>> VENDORSPEC_FRC_SDCLK_ON to control card clock output""), it
>> involve issue in mmc_switch_voltage(), because of the special
>> design of usdhc.
>>
>> For FSL_USDHC, it do not implement VENDORSPEC_CKEN/PEREN/HCKEN/IPGEN,
>> these are reserved bits(Though RM contain the definition of these bits,
>> but actually internal IC logic do not implement, already confirm with
>> IC team). Instead, use VENDORSPEC_FRC_SDCLK_ON to gate on/off the card
>> clock output. Here is the definition of this bit in RM:
>>
>> [8] FRC_SDCLK_ON
>> Force CLK output active
>> Do not set this bit to 1 unless it is necessary. Also, make sure that
>> this bit is cleared when uSDHC’s clock is about to be changed (frequency
>> change, clock source change, or delay chain tuning).
>> 0b - CLK active or inactive is fully controlled by the hardware.
>> 1b - Force CLK active
>>
>> In default, the FRC_SDCLK_ON is 0. This means, when there is no command
>> or data transfer on bus, hardware will gate off the card clock. But in
>> some case, we need the card clock keep on. Take IO voltage 1.8v switch
>> as example, after IO voltage change to 1.8v, spec require gate off the
>> card clock for 5ms, and gate on the clock back, once detect the card
>> clock on, then the card will draw the dat0 to high immediately. If there
>> is not clock gate off/on behavior, some card will keep the dat0 to low
>> level. This is the reason we fail in mmc_switch_voltage().
>>
>> To fix this issue, and concern that this is only the fsl usdhc hardware
>> design limitation, set the bit FRC_SDCLK_ON in the beginning of the
>> wait_dat0() and clear it in the end. To make sure the 1.8v IO voltage
>> switch process align with SD specification.
>>
>> For standard tuning process, usdhc specification also require the card
>> clock keep on, so also add these behavior in fsl_esdhc_execute_tuning().
>>
>> Reviewed-by: Marek Vasut <marex at denx.de>
>> Tested-by: Fabio Estevam <festevam at gmail.com>
>> Signed-off-by: Haibo Chen <haibo.chen at nxp.com>
>> Reviewed-by: Peng Fan <peng.fan at nxp.com>
>> Reviewed-by: Jaehoon Chung <jh80.chung at samsung.com>
>> ---
>>  drivers/mmc/fsl_esdhc_imx.c | 25 ++++++++++++++++++++++---
>>  include/fsl_esdhc_imx.h     |  2 ++
>>  2 files changed, 24 insertions(+), 3 deletions(-)
> 
> Is this going to get picked up in the imx or mmc trees soon, or should I
> take this directly?  Thanks!

Applied to u-boot-mmc. Thanks! Sorry for late.

Best Regards,
Jaehoon Chung

>