[PATCH 2/2] board: tbs2910: Convert to DM_SERIAL

[Soeren Moch]

Hi Fabio,

On 15.03.22 21:56, Soeren Moch wrote:
> Hi Fabio,
>
> On 15.03.22 00:16, Fabio Estevam wrote:
>> Hi Soeren,
>>
>> On Mon, Mar 14, 2022 at 7:38 PM Tom Rini <trini at konsulko.com> wrote:
>>
>>> Again, DM_SERIAL can be enabled on the board as he's already shown by
>>> setting two options, which silences the warning, increases the size and
>>> doesn't make anything better.  That's likely what the other boards are
>>> doing, or they're just having some console output be missing. What
>>> would need to be set where, so that serial output isn't missing,
>>> without
>>> having to manually call setup_iomux_uart() like so many imx platforms
>>> are doing.
>> Does the attached patch work for you?
>>
>> I tested a similar patch on warp7 and it works fine here and the early
>> U-Boot messages are shown.
> This looks quite similar to my first attempt on this, but with
> additional pre-reloc attributes on aips1, pinctrl_uart1, and soc.
> Quite promising, probably exactly the right solution that I was
> looking for.
>
> I promise to test this still this week, but may not be able to do so
> before the weekend.
Your patch works great, I already sent my Tested-by to patchwork.
So my patch should be dropped in favour of your one, but I saw that
my patch already is marked 'Superseded'.

Regards,
Soeren
>
> Thanks for working on this,
> Soeren