[PATCH 3/6] net: zynq_gem: Move ethernet info print statement

[Michal Simek]

From: T Karthik Reddy <t.karthik.reddy at xilinx.com>

As we are not reading the PHY address in case of CONFIG_ETH_PHY in plat
function, phy address always prints as -1. So move the ethernet info
print statement to probe function, to display proper phy address.

Signed-off-by: T Karthik Reddy <t.karthik.reddy at xilinx.com>
Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

 drivers/net/zynq_gem.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 168aabbdd006..07de1bf0a40e 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -802,6 +802,10 @@ static int zynq_gem_probe(struct udevice *dev)
 			return ret;
 	}
 
+	printf("\nZYNQ GEM: %lx, mdio bus %lx, phyaddr %d, interface %s\n",
+	       (ulong)priv->iobase, (ulong)priv->mdiobase, priv->phydev->addr,
+	       phy_string_for_interface(priv->interface));
+
 	return ret;
 
 err3:
@@ -884,10 +888,6 @@ static int zynq_gem_of_to_plat(struct udevice *dev)
 
 	priv->int_pcs = dev_read_bool(dev, "is-internal-pcspma");
 
-	printf("\nZYNQ GEM: %lx, mdio bus %lx, phyaddr %d, interface %s\n",
-	       (ulong)priv->iobase, (ulong)priv->mdiobase, priv->phyaddr,
-	       phy_string_for_interface(priv->interface));
-
 	priv->clk_en_info = dev_get_driver_data(dev);
 
 	return 0;
-- 
2.35.1