[PATCH v4 18/25] net: mediatek: use regmap api to modify ethsys registers

Ramon Fried rfried.dev at gmail.com
Mon May 16 02:25:30 CEST 2022


On Tue, May 10, 2022 at 3:20 PM Weijie Gao <weijie.gao at mediatek.com> wrote:
>
> The address returned by regmap_get_range() is not remapped. Directly r/w
> to this address is ok for ARM platforms since it's idential to the virtual
> address.
>
> But for MIPS platform only virtual address should be used for access.
> To solve this issue, the regmap api regmap_read/regmap_write should be used
> since they will remap address before accessing.
>
> Signed-off-by: Weijie Gao <weijie.gao at mediatek.com>
> ---
> v4 changes: new
> ---
>  drivers/net/mtk_eth.c | 22 +++++++++++-----------
>  1 file changed, 11 insertions(+), 11 deletions(-)
>
> diff --git a/drivers/net/mtk_eth.c b/drivers/net/mtk_eth.c
> index caa83b7cec..ac1e8abd71 100644
> --- a/drivers/net/mtk_eth.c
> +++ b/drivers/net/mtk_eth.c
> @@ -159,9 +159,10 @@ struct mtk_eth_priv {
>
>         void __iomem *fe_base;
>         void __iomem *gmac_base;
> -       void __iomem *ethsys_base;
>         void __iomem *sgmii_base;
>
> +       struct regmap *ethsys_regmap;
> +
>         struct mii_dev *mdio_bus;
>         int (*mii_read)(struct mtk_eth_priv *priv, u8 phy, u8 reg);
>         int (*mii_write)(struct mtk_eth_priv *priv, u8 phy, u8 reg, u16 val);
> @@ -233,7 +234,12 @@ static void mtk_gmac_rmw(struct mtk_eth_priv *priv, u32 reg, u32 clr, u32 set)
>  static void mtk_ethsys_rmw(struct mtk_eth_priv *priv, u32 reg, u32 clr,
>                            u32 set)
>  {
> -       clrsetbits_le32(priv->ethsys_base + reg, clr, set);
> +       uint val;
> +
> +       regmap_read(priv->ethsys_regmap, reg, &val);
> +       val &= ~clr;
> +       val |= set;
> +       regmap_write(priv->ethsys_regmap, reg, val);
>  }
>
>  /* Direct MDIO clause 22/45 access via SoC */
> @@ -1427,15 +1433,9 @@ static int mtk_eth_of_to_plat(struct udevice *dev)
>         if (ret)
>                 return ret;
>
> -       regmap = syscon_node_to_regmap(args.node);
> -       if (IS_ERR(regmap))
> -               return PTR_ERR(regmap);
> -
> -       priv->ethsys_base = regmap_get_range(regmap, 0);
> -       if (!priv->ethsys_base) {
> -               dev_err(dev, "Unable to find ethsys\n");
> -               return -ENODEV;
> -       }
> +       priv->ethsys_regmap = syscon_node_to_regmap(args.node);
> +       if (IS_ERR(priv->ethsys_regmap))
> +               return PTR_ERR(priv->ethsys_regmap);
>
>         /* Reset controllers */
>         ret = reset_get_by_name(dev, "fe", &priv->rst_fe);
> --
> 2.17.1
>
Reviewed-by: Ramon Fried <rfried.dev at gmail.com>


More information about the U-Boot mailing list