[PATCH 1/2] sunxi: Skip MMC0 init when its pinmux conflicts with UART0

[Andre Przywara]

On Sun, 10 Apr 2022 00:13:33 -0500
Samuel Holland <samuel at sholland.org> wrote:

> Currently, selecting UART0_PORT_F entirely disables MMC support on sunxi
> platforms. But this is a bigger hammer then needed. Muxing UART0 to the
> pins on port F only causes a conflict with MMC0, so minimize the impact
> by specifically skipping MMC0 init. We can continue to use MMC1/2 if
> those are enabled.
> 
> Let's also remove the preprocessor check while refacting this function.
> 
> Signed-off-by: Samuel Holland <samuel at sholland.org>

Applied to sunxi/master.

Thanks,
Andre

> ---
> 
>  board/sunxi/board.c | 22 ++++++++++------------
>  1 file changed, 10 insertions(+), 12 deletions(-)
> 
> diff --git a/board/sunxi/board.c b/board/sunxi/board.c
> index 89324159d5..7822001d99 100644
> --- a/board/sunxi/board.c
> +++ b/board/sunxi/board.c
> @@ -516,19 +516,17 @@ static void mmc_pinmux_setup(int sdc)
>  
>  int board_mmc_init(struct bd_info *bis)
>  {
> -	__maybe_unused struct mmc *mmc0, *mmc1;
> -
> -	mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT);
> -	mmc0 = sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT);
> -	if (!mmc0)
> -		return -1;
> +	if (!IS_ENABLED(CONFIG_UART0_PORT_F)) {
> +		mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT);
> +		if (!sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT))
> +			return -1;
> +	}
>  
> -#if CONFIG_MMC_SUNXI_SLOT_EXTRA != -1
> -	mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT_EXTRA);
> -	mmc1 = sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT_EXTRA);
> -	if (!mmc1)
> -		return -1;
> -#endif
> +	if (CONFIG_MMC_SUNXI_SLOT_EXTRA != -1) {
> +		mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT_EXTRA);
> +		if (!sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT_EXTRA))
> +			return -1;
> +	}
>  
>  	return 0;
>  }