[PATCH v2 1/2] serial: mxc: enable the RX pipeline

[Peng Fan]

On 9/5/2022 5:58 PM, Johannes Schneider wrote:
> on imx8(mm) the RXDMUXSEL needs to be set for data going over the wire
> (as observable on a connected 'scope) to actually make it into the
> RXFIFO
> 
> the reference manual is not overly clear about this, and only
> mentiones that "UCR3_RXDMUXSEL should always be set." - and since the
> CR3 register reverts to its reset values after setting the baudrate,
> setting this bit is done during '_mxc_serial_setbgr'
> 
> Signed-off-by: Johannes Schneider <johannes.schneider at leica-geosystems.com>
> 
> ---
> 
> (no changes since v1)
> 
>   drivers/serial/serial_mxc.c | 11 +++++++++++
>   1 file changed, 11 insertions(+)
> 
> diff --git a/drivers/serial/serial_mxc.c b/drivers/serial/serial_mxc.c
> index 70a0e5e919..5f283cc635 100644
> --- a/drivers/serial/serial_mxc.c
> +++ b/drivers/serial/serial_mxc.c
> @@ -61,6 +61,11 @@
>   #define UCR3_AWAKEN	(1<<4)  /* Async wake interrupt enable */
>   #define UCR3_REF25	(1<<3)  /* Ref freq 25 MHz */
>   #define UCR3_REF30	(1<<2)  /* Ref Freq 30 MHz */
> +
> +//imx8 names these bitsfields instead:
> +#define UCR3_DTRDEN	BIT(3)  /* bit not used in this chip */
> +#define UCR3_RXDMUXSEL	BIT(2)  /* RXD muxed input selected; 'should always be set' */
> +
>   #define UCR3_INVT	(1<<1)  /* Inverted Infrared transmission */
>   #define UCR3_BPEN	(1<<0)  /* Preset registers enable */
>   #define UCR4_CTSTL_32	(32<<10) /* CTS trigger level (32 chars) */
> @@ -176,6 +181,12 @@ static void _mxc_serial_setbrg(struct mxc_uart *base, unsigned long clk,
>   
>   	writel(UCR2_WS | UCR2_IRTS | UCR2_RXEN | UCR2_TXEN | UCR2_SRST,
>   	       &base->cr2);
> +
> +	// setting the baudrate triggers a reset, returning cr3 to its
> +	// reset value but UCR3_RXDMUXSEL "should always be set."
> +	// according to the imx8 reference-manual
> +	writel(readl(&base->cr3) | UCR3_RXDMUXSEL, &base->cr3);

Please fix comment format.

I just give a look at i.MX6QDL, i.MX7D, i.MX8M*, this bit should be set 
for them all.

Thanks,
Peng.

> +
>   	writel(UCR1_UARTEN, &base->cr1);
>   }
>