[PATCH v1 3/5] arm64: dts: verdin-imx8mm: add ctrl_sleep_moci# hog

[sbabic at denx.de]

> From: Andrejs Cainikovs <andrejs.cainikovs at toradex.com>
> Drive CTRL_SLEEP_MOCI# high at boot (SPL) using a GPIO hog, this signal
> may be used to control some power-rails on the carrier board, therefore
> it should be set to high when the module is booting.
> To do this as early as possible is generally a good idea and the issue
> was noticed on the Yavia carrier board where it is needed to power the
> I2C EEPROM on the carrier board.
> Signed-off-by: Andrejs Cainikovs <andrejs.cainikovs at toradex.com>
> Signed-off-by: Marcel Ziswiler <marcel.ziswiler at toradex.com>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,        Managing Director: Erika Unter  
HRB 165235 Munich,   Office: Kirchenstr.5, 82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================