[PATCH] pinephone-pro: Fix I/O port voltage (GPIO3D4A is 1.8V)

[Peter Robinson]

On Thu, May 25, 2023 at 2:27 PM Ondřej Jirman <megi at xff.cz> wrote:
>
> From: Ondrej Jirman <megi at xff.cz>
>
> This fixes access to camera sensor over I2C during probe time in
> the kernel. (Kernel will fix I/0 port voltage by itself, but the
> timing depends on probe order of the drivers, so the fix can
> come after the camera sensor driver already failed to probe.)
>
> Signed-off-by: Ondrej Jirman <megi at xff.cz>
Reviewed-by: Peter Robinson <pbrobinson at gmail.com>
Tested-by: Peter Robinson <pbrobinson at gmail.com>
> Cc: Kever Yang <kever.yang at rock-chips.com>
> ---
>  board/pine64/pinephone-pro-rk3399/pinephone-pro-rk3399.c | 6 ++++--
>  1 file changed, 4 insertions(+), 2 deletions(-)
>
> diff --git a/board/pine64/pinephone-pro-rk3399/pinephone-pro-rk3399.c b/board/pine64/pinephone-pro-rk3399/pinephone-pro-rk3399.c
> index eb639cd0d070..b6ccbb9c1c4b 100644
> --- a/board/pine64/pinephone-pro-rk3399/pinephone-pro-rk3399.c
> +++ b/board/pine64/pinephone-pro-rk3399/pinephone-pro-rk3399.c
> @@ -15,7 +15,8 @@
>  #include <asm/arch-rockchip/misc.h>
>  #include <power/regulator.h>
>
> -#define GRF_IO_VSEL_BT565_SHIFT 0
> +#define GRF_IO_VSEL_BT565_GPIO2AB 1
> +#define GRF_IO_VSEL_AUDIO_GPIO3D4A 2
>  #define PMUGRF_CON0_VSEL_SHIFT 8
>
>  #ifndef CONFIG_SPL_BUILD
> @@ -48,7 +49,8 @@ static void setup_iodomain(void)
>            syscon_get_first_range(ROCKCHIP_SYSCON_PMUGRF);
>
>         /* BT565 is in 1.8v domain */
> -       rk_setreg(&grf->io_vsel, 1 << GRF_IO_VSEL_BT565_SHIFT);
> +       rk_setreg(&grf->io_vsel,
> +                 GRF_IO_VSEL_BT565_GPIO2AB | GRF_IO_VSEL_AUDIO_GPIO3D4A);
>
>         /* Set GPIO1 1.8v/3.0v source select to PMU1830_VOL */
>         rk_setreg(&pmugrf->soc_con0, 1 << PMUGRF_CON0_VSEL_SHIFT);
> --
> 2.40.1
>