Pull request: please pull u-boot-imx-20230503

[Fabio Estevam]

Hi Tom,

On Wed, May 3, 2023 at 4:01 PM Tom Rini <trini at konsulko.com> wrote:

> So, both my HW test and CI is fine, so I've applied this.  But please
> note we now have this scary message to fix:
> +(imx8qm_dmsse20a1) aarch64-linux-ld.bfd: invalid origin for memory region .sdram

I compared the imx8qm_dmsse20a1 against imx8qm_mek_defconfig and with
the following changes the warning is gone:

--- a/configs/imx8qm_dmsse20a1_defconfig
+++ b/configs/imx8qm_dmsse20a1_defconfig
@@ -16,6 +16,7 @@ CONFIG_SPL_SERIAL=y
 CONFIG_SPL_DRIVERS_MISC=y
 CONFIG_ENV_OFFSET=0x80000
 CONFIG_ENV_SECT_SIZE=0x20000
+CONFIG_SPL_STACK=0x13e000
 CONFIG_SPL=y
 CONFIG_SYS_LOAD_ADDR=0x80280000
 CONFIG_SYS_MEMTEST_START=0xA0000000
@@ -38,11 +39,17 @@ CONFIG_USE_BOOTCOMMAND=y
 CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run
loadbootscript; then run bootscript; else if run loadimage; then run
mmcboot; else run netboot; fi; fi; else booti ${loadaddr} -
${fdt_addr}; fi"
 CONFIG_LOG=y
 CONFIG_BOARD_EARLY_INIT_F=y
-CONFIG_SPL_BSS_START_ADDR=0x00128000
 CONFIG_SPL_MAX_SIZE=0x1f000
+CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
+CONFIG_SPL_BSS_START_ADDR=0x128000
 CONFIG_SPL_BSS_MAX_SIZE=0x1000
 CONFIG_SPL_BOARD_INIT=y
-CONFIG_SPL_SEPARATE_BSS=y
+CONFIG_SPL_SYS_MALLOC_SIMPLE=y
+# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
+CONFIG_SYS_SPL_MALLOC=y
+CONFIG_HAS_CUSTOM_SPL_MALLOC_START=y
+CONFIG_CUSTOM_SYS_SPL_MALLOC_ADDR=0x120000
+CONFIG_SYS_SPL_MALLOC_SIZE=0x3000
 CONFIG_SPL_POWER_SUPPORT=y
 CONFIG_SPL_POWER_DOMAIN=y
 CONFIG_SPL_WATCHDOG_SUPPORT=y

Oliver, could you please test this change?

I can submit it formally if it works for you.