Pull request: please pull u-boot-imx-20230503

[Oliver Graute]

> Am 03.05.2023 um 23:25 schrieb Fabio Estevam <festevam at gmail.com>:
> 
> --- a/configs/imx8qm_dmsse20a1_defconfig
> +++ b/configs/imx8qm_dmsse20a1_defconfig
> @@ -16,6 +16,7 @@ CONFIG_SPL_SERIAL=y
> CONFIG_SPL_DRIVERS_MISC=y
> CONFIG_ENV_OFFSET=0x80000
> CONFIG_ENV_SECT_SIZE=0x20000
> +CONFIG_SPL_STACK=0x13e000
> CONFIG_SPL=y
> CONFIG_SYS_LOAD_ADDR=0x80280000
> CONFIG_SYS_MEMTEST_START=0xA0000000
> @@ -38,11 +39,17 @@ CONFIG_USE_BOOTCOMMAND=y
> CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run
> loadbootscript; then run bootscript; else if run loadimage; then run
> mmcboot; else run netboot; fi; fi; else booti ${loadaddr} -
> ${fdt_addr}; fi"
> CONFIG_LOG=y
> CONFIG_BOARD_EARLY_INIT_F=y
> -CONFIG_SPL_BSS_START_ADDR=0x00128000
> CONFIG_SPL_MAX_SIZE=0x1f000
> +CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
> +CONFIG_SPL_BSS_START_ADDR=0x128000
> CONFIG_SPL_BSS_MAX_SIZE=0x1000
> CONFIG_SPL_BOARD_INIT=y
> -CONFIG_SPL_SEPARATE_BSS=y
> +CONFIG_SPL_SYS_MALLOC_SIMPLE=y
> +# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
> +CONFIG_SYS_SPL_MALLOC=y
> +CONFIG_HAS_CUSTOM_SPL_MALLOC_START=y
> +CONFIG_CUSTOM_SYS_SPL_MALLOC_ADDR=0x120000
> +CONFIG_SYS_SPL_MALLOC_SIZE=0x3000
> CONFIG_SPL_POWER_SUPPORT=y
> CONFIG_SPL_POWER_DOMAIN=y
> CONFIG_SPL_WATCHDOG_SUPPORT=y

Hello Fabio,

just tested this change and its working fine on the dmsse20a1 board.

Tested-by: Oliver Graute <oliver.graute at kococonnector.com>

Best regards,

Oliver