[PATCH v1 1/2] configs: starfive: Enable PCIE auto enum and NVME/USB stuff for Starfive Visionfive 2

[Dennis Gilmore]

On Tue, Aug 22, 2023 at 9:34 AM Shengyu Qu <wiagn233 at outlook.com> wrote:

> Although PCIE driver already exists, board defconfig isn't configured to
> enable PCIE enum on boot, thus USB storage device and NVME drive are not
> supported by default. So modify defconfig to enable PCIE auto enum, then
> start USB subsystem and scan nvme drive on boot.
>
> Signed-off-by: Shengyu Qu <wiagn233 at outlook.com>
>
Tested-by: Dennis Gilmore <dennis at ausil.us>

> ---
>  configs/starfive_visionfive2_defconfig | 8 +++++++-
>  1 file changed, 7 insertions(+), 1 deletion(-)
>
> diff --git a/configs/starfive_visionfive2_defconfig
> b/configs/starfive_visionfive2_defconfig
> index e9b63e5b84..3002c96f0e 100644
> --- a/configs/starfive_visionfive2_defconfig
> +++ b/configs/starfive_visionfive2_defconfig
> @@ -30,6 +30,7 @@ CONFIG_SPL_SPI=y
>  CONFIG_SYS_LOAD_ADDR=0x82000000
>  CONFIG_SYS_PCI_64BIT=y
>  CONFIG_PCI=y
> +CONFIG_PCI_INIT_R=y
>  CONFIG_TARGET_STARFIVE_VISIONFIVE2=y
>  CONFIG_SPL_OPENSBI_LOAD_ADDR=0x40000000
>  CONFIG_ARCH_RV64I=y
> @@ -43,7 +44,7 @@ CONFIG_SD_BOOT=y
>  CONFIG_USE_BOOTARGS=y
>  CONFIG_BOOTARGS="console=ttyS0,115200 debug rootwait earlycon=sbi"
>  CONFIG_USE_PREBOOT=y
> -CONFIG_PREBOOT="setenv fdt_addr ${fdtcontroladdr};fdt addr
> ${fdtcontroladdr};"
> +CONFIG_PREBOOT="nvme scan; usb start; setenv fdt_addr ${fdtcontroladdr};
> fdt addr ${fdtcontroladdr};"
>  CONFIG_DEFAULT_FDT_FILE="starfive/jh7110-starfive-visionfive-2.dtb"
>  CONFIG_DISPLAY_CPUINFO=y
>  CONFIG_DISPLAY_BOARDINFO=y
> @@ -124,4 +125,9 @@ CONFIG_TIMER_EARLY=y
>  CONFIG_USB=y
>  CONFIG_USB_XHCI_HCD=y
>  CONFIG_USB_XHCI_PCI=y
> +CONFIG_USB_EHCI_HCD=y
> +CONFIG_USB_EHCI_PCI=y
> +CONFIG_USB_OHCI_HCD=y
> +CONFIG_USB_OHCI_PCI=y
> +CONFIG_USB_STORAGE=y
>  CONFIG_USB_KEYBOARD=y
> --
> 2.42.0
>
>