[PATCH v1 4/6] configs: stm32mp13: activate command stm32prog

[Patrice Chotard]

From: Patrick Delaunay <patrick.delaunay at foss.st.com>

Activate the command stm32prog with CONFIG_CMD_STM32MPROG.
The CONFIG_SET_DFU_ALT_INFO is also activated to support
the required weak functions for the DFU virtual backen defined in
board/st/common/stm32mp_dfu.c.

Signed-off-by: Patrick Delaunay <patrick.delaunay at foss.st.com>
Signed-off-by: Patrice Chotard <patrice.chotard at foss.st.com>
---

 configs/stm32mp13_defconfig        | 2 ++
 include/configs/stm32mp13_common.h | 4 ++++
 2 files changed, 6 insertions(+)

diff --git a/configs/stm32mp13_defconfig b/configs/stm32mp13_defconfig
index f962d0eab97..2d87792a9cb 100644
--- a/configs/stm32mp13_defconfig
+++ b/configs/stm32mp13_defconfig
@@ -11,6 +11,7 @@ CONFIG_DDR_CACHEABLE_SIZE=0x8000000
 CONFIG_CMD_STM32KEY=y
 CONFIG_TARGET_ST_STM32MP13x=y
 CONFIG_ENV_OFFSET_REDUND=0x940000
+CONFIG_CMD_STM32PROG=y
 # CONFIG_ARMV7_NONSEC is not set
 CONFIG_SYS_LOAD_ADDR=0xc2000000
 CONFIG_SYS_MEMTEST_START=0xc0000000
@@ -51,6 +52,7 @@ CONFIG_SYS_RELOC_GD_ENV_ADDR=y
 CONFIG_SYS_MMC_ENV_DEV=-1
 CONFIG_ENV_MMC_USE_DT=y
 CONFIG_CLK_SCMI=y
+CONFIG_SET_DFU_ALT_INFO=y
 CONFIG_GPIO_HOG=y
 CONFIG_DM_I2C=y
 CONFIG_SYS_I2C_STM32F7=y
diff --git a/include/configs/stm32mp13_common.h b/include/configs/stm32mp13_common.h
index 7c59c69e0bd..d36fbf00548 100644
--- a/include/configs/stm32mp13_common.h
+++ b/include/configs/stm32mp13_common.h
@@ -41,10 +41,14 @@
 
 /*
  * default bootcmd for stm32mp13:
+ * for serial/usb: execute the stm32prog command
  * for mmc boot (eMMC, SD card), distro boot on the same mmc device
  */
 #define STM32MP_BOOTCMD "bootcmd_stm32mp=" \
 	"echo \"Boot over ${boot_device}${boot_instance}!\";" \
+	"if test ${boot_device} = serial || test ${boot_device} = usb;" \
+	"then stm32prog ${boot_device} ${boot_instance}; " \
+	"else " \
 		"run env_check;" \
 		"if test ${boot_device} = mmc;" \
 		"then env set boot_targets \"mmc${boot_instance}\"; fi;" \
-- 
2.25.1