[PATCH v4 2/6] arm: mach-k3: j721e_init: Move clk_k3 probe before loading TIFS

[Manorit Chawdhry]

Hi Neha,

On 18:39-20230927, Neha Malcom Francis wrote:
> When setting boot media to load the TIFS binary in legacy boot flow
> (followed by J721E), get_timer() is called which eventually calls
> dm_timer_init() to grab the tick-timer, which is mcu_timer0. Since we
> need to set up the clocks before using the timer, move clk_k3 driver
> probe before k3_sysfw_loader to ensure we have all necessary clocks set
> up before.
> 
> Signed-off-by: Neha Malcom Francis <n-francis at ti.com>
> Reviewed-by: Nishanth Menon <nm at ti.com>
> ---
>  arch/arm/mach-k3/j721e_init.c | 24 ++++++++++++------------
>  1 file changed, 12 insertions(+), 12 deletions(-)
> 
> index b6164575b7..b1f7e25ed0 100644
> --- a/arch/arm/mach-k3/j721e_init.c
> +++ b/arch/arm/mach-k3/j721e_init.c
> @@ -228,6 +228,18 @@ void board_init_f(ulong dummy)
>  	if (!ret)
>  		pinctrl_select_state(dev, "default");
>  
> +	/*
> +	 * Force probe of clk_k3 driver here to ensure basic default clock
> +	 * configuration is always done.
> +	 */
> +	if (IS_ENABLED(CONFIG_SPL_CLK_K3)) {
> +		ret = uclass_get_device_by_driver(UCLASS_CLK,
> +						  DM_DRIVER_GET(ti_clk),
> +						  &dev);
> +		if (ret)
> +			panic("Failed to initialize clk-k3!\n");
> +	}
> +
>  	/*
>  	 * Load, start up, and configure system controller firmware. Provide
>  	 * the U-Boot console init function to the SYSFW post-PM configuration
> @@ -241,18 +253,6 @@ void board_init_f(ulong dummy)
>  	do_dt_magic();
>  #endif
>  
> -	/*
> -	 * Force probe of clk_k3 driver here to ensure basic default clock
> -	 * configuration is always done.
> -	 */
> -	if (IS_ENABLED(CONFIG_SPL_CLK_K3)) {
> -		ret = uclass_get_device_by_driver(UCLASS_CLK,
> -						  DM_DRIVER_GET(ti_clk),
> -						  &dev);
> -		if (ret)
> -			panic("Failed to initialize clk-k3!\n");
> -	}
> -
>  	/* Prepare console output */
>  	preloader_console_init();
>  

Reviewed-by: Manorit Chawdhry <m-chawdhry at ti.com>

Regards,
Manorit

> diff --git a/arch/arm/mach-k3/j721e_init.c b/arch/arm/mach-k3/j721e_init.c
> -- 
> 2.34.1
>