[PATCH v1 11/25] ARM: dts: stm32: Don't probe red led at boot for stm32mp157a-dk1-scmi-u-boot

[Patrice Chotard]

red led and button dedicated to fastboot share the same gpio GPIOA13.
Led driver is probed early so the corresponding gpio is taken and
configured in output which forbid fastboot and stm32prog button usage.

To avoid this, remove the "default-state" property from red led node.

This will avoid to trigger the led driver probe() to configure the led
default state during startup.

Signed-off-by: Patrice Chotard <patrice.chotard at foss.st.com>
---

 arch/arm/dts/stm32mp157a-dk1-scmi-u-boot.dtsi | 1 -
 1 file changed, 1 deletion(-)

diff --git a/arch/arm/dts/stm32mp157a-dk1-scmi-u-boot.dtsi b/arch/arm/dts/stm32mp157a-dk1-scmi-u-boot.dtsi
index 5d49b09c35d..8760d6c7d93 100644
--- a/arch/arm/dts/stm32mp157a-dk1-scmi-u-boot.dtsi
+++ b/arch/arm/dts/stm32mp157a-dk1-scmi-u-boot.dtsi
@@ -39,7 +39,6 @@
 		red {
 			label = "error";
 			gpios = <&gpioa 13 GPIO_ACTIVE_LOW>;
-			default-state = "off";
 			status = "okay";
 		};
 	};
-- 
2.25.1