pinctrl warning on sandbox

[Simon Glass]

Hi Sean,

On Fri, 9 Aug 2024 at 07:31, Sean Anderson <seanga2 at gmail.com> wrote:
>
> Hi Simon,
>
> On 8/7/24 19:17, Simon Glass wrote:
> > Hi Sean,
> >
> > I was looking at [1] and bisected the message to this commit:
> >
> > 7f0f1806e3a (refs/bisect/bad) test: pinmux: Add test for pin muxing
> >
> > I'm not quite sure what is going on, but could you please take a look?
> >
> > Regards,
> > Simon
> >
> > [1] https://source.denx.de/u-boot/u-boot/-/issues/2
>
> That test run is pretty old. Does the error always occur during EFI tests?
> You said in IRC it occurs on current master; can you send a link?

Yes, it happens whenever sandbox is run with the device tree. This is
sandbox build from -next:

$ /tmp/b/sandbox/u-boot -D
Bloblist at b000 not found (err=-2)
sandbox_serial serial: pinctrl_select_state_full:
uclass_get_device_by_phandle_id: err=-19


U-Boot 2024.10-rc2-00021-gb63f30d4ae6a-dirty (Aug 08 2024 - 12:46:24 -0600)

Reset Status: COLD
Model: sandbox
DRAM:  256 MiB

Warning: host_lo MAC addresses don't match:
Address in ROM is b2:e9:3c:a1:b3:05
Address in environment is 02:00:11:22:33:44
sandbox_serial serial: pinctrl_select_state_full: pinctrl_config_one: err=-38
Core:  117 devices, 61 uclasses, devicetree: board
WDT:   Started alarm-wdt with servicing every 1000ms (5s timeout)
NAND:  0 MiB
MMC:
Loading Environment from nowhere... OK
Warning: device tree node '/config/environment' not found
In:    serial,cros-ec-keyb,usbkbd
Out:   serial,vidconsole
Err:   serial,vidconsole
Model: sandbox
Net:   eth0: host_lo, eth1: host_enp14s0, eth2: host_eth6, eth3:
host_wlp15s0, eth4: host_docker0
Error: eth at 10002000 No valid MAC address found.


Hit any key to stop autoboot:  0
=>

Regards,
Simon