[resend v2 00/19] Add Cadence NAND Driver support

[Michael Nazzareno Trimarchi]

Hi

On Thu, Dec 5, 2024 at 10:23 AM <dinesh.maniyam at intel.com> wrote:
>
> From: Dinesh Maniyam <dinesh.maniyam at intel.com>
>
> This patchset add Cadence NAND driver support for
> Intel Agilex5 devices.
>
> The NAND driver is leveraged from the cadence-nand-controller.c
> from Linux version 6.11.2. U-Boot will support read, write and erase
> NAND with Cadence driver. The driver further enhanced in U-Boot
> to support NAND booting from FSBL and support boot to kernel
> via UBIFS.
>
> Patch status:
> Have changes: All patches expect Patch 19
>
> Detail changelog can find in commit message.
>
> v1->v2:
> --------
> Patch 1 - 18:
>
> - remove the "this patch is to" commit phrases
>
> Patch 4;
> - minor refactoring of code to match the stable version 6.11.2.
>
> Patch 14:
> - Add maintainer and "#include" mechanism for new variant
>
> Patch 16:
> - leverage the existing nand_spl_load_image
>

I have tried to build but it does not work. Have you tested in github?

Michael

> History:
> --------
> [v1]: https://patchwork.ozlabs.org/project/uboot/cover/20240919035512.13854-1-dinesh.maniyam@intel.com/
>
> Dinesh Maniyam (19):
>   dt: nand: add cadence nand dt-bindings
>   arm: dts: agilex5: Enabled cdns-nand dts setting
>   include: asm: Add support to read/write 64-bit
>   drivers: mtd: nand: Add driver for Cadence Nand
>   drivers: mtd: nand: cadence: Add support for read status command
>   drivers: mtd: nand: cadence: Add support for readid command
>   drivers: mtd: nand: cadence: Add support for NAND_CMD_PARAM
>   drivers: mtd: nand: cadence: Add support for NAND_CMD_RESET
>   drivers: mtd: nand: cadence: Support cmd SET_FEATURES & GET_FEATURES
>   drivers: mtd: nand: cadence: Flush & invalidate dma descriptor
>   drivers: mtd: nand: cadence: Poll for desc complete status
>   drivers: mtd: nand: cadence: Use bounce buffer
>   drivers: nand: Enabled Kconfig and Makefile for cdns-nand
>   configs: nand2_defconfig: Enable configs for nand boot
>   drivers: mtd: nand: base: Add support for Hardware ECC for check bad
>     block
>   drivers: mtd: nand: spl: Add support for nand SPL load image
>   drivers: mtd: nand: Enabled Kconfig and Makefile for Cadence-SPL
>   drivers: mtd: nand: Kconfig: Remove SYS_NAND_BLOCK_SIZE dependency
>   drivers: mtd: nand: Kconfig: Enabled self-init for cdns-nand SPL
>
>  arch/arm/dts/socfpga_agilex5.dtsi             |   14 +
>  .../arm/dts/socfpga_agilex5_socdk-u-boot.dtsi |   28 +
>  arch/arm/include/asm/io.h                     |   25 +
>  board/intel/agilex5-socdk/MAINTAINERS         |    2 +
>  configs/socfpga_agilex5_nand2_defconfig       |   33 +
>  .../mtd/cadence,nand.yaml                     |   98 +
>  drivers/mtd/nand/raw/Kconfig                  |   19 +-
>  drivers/mtd/nand/raw/Makefile                 |    2 +
>  drivers/mtd/nand/raw/cadence_nand.c           | 2424 +++++++++++++++++
>  drivers/mtd/nand/raw/cadence_spl.c            |   59 +
>  drivers/mtd/nand/raw/nand_base.c              |   71 +-
>  include/cadence-nand.h                        |  529 ++++
>  include/linux/mtd/rawnand.h                   |   14 +
>  13 files changed, 3293 insertions(+), 25 deletions(-)
>  create mode 100644 configs/socfpga_agilex5_nand2_defconfig
>  create mode 100644 doc/device-tree-bindings/mtd/cadence,nand.yaml
>  create mode 100644 drivers/mtd/nand/raw/cadence_nand.c
>  create mode 100644 drivers/mtd/nand/raw/cadence_spl.c
>  create mode 100644 include/cadence-nand.h
>
> --
> 2.19.0
>


-- 
Michael Nazzareno Trimarchi
Co-Founder & Chief Executive Officer
M. +39 347 913 2170
michael at amarulasolutions.com
__________________________________

Amarula Solutions BV
Joop Geesinkweg 125, 1114 AB, Amsterdam, NL
T. +31 (0)85 111 9172
info at amarulasolutions.com
www.amarulasolutions.com