[PATCH v1] doc: imx: imxrt1170: Document imxrt1170-evk board

Giulio Benetti giulio.benetti at benettiengineering.com
Thu Feb 1 17:19:15 CET 2024


Hi Jesse,

On 01/02/24 16:00, Jesse Taube wrote:
> Add documentation for imxrt1170-evk.
> 
> Signed-off-by: Jesse Taube <Mr.Bossman075 at gmail.com>

looks good to me

Reviewed-by: Giulio Benetti <giulio.benetti at benettiengineering.com>

Best regards
-- 
Giulio Benetti
CEO&CTO at Benetti Engineering sas

> ---
>   doc/board/nxp/imxrt1170-evk.rst | 42 +++++++++++++++++++++++++++++++++
>   1 file changed, 42 insertions(+)
>   create mode 100644 doc/board/nxp/imxrt1170-evk.rst
> 
> diff --git a/doc/board/nxp/imxrt1170-evk.rst b/doc/board/nxp/imxrt1170-evk.rst
> new file mode 100644
> index 0000000000..4acccdcc93
> --- /dev/null
> +++ b/doc/board/nxp/imxrt1170-evk.rst
> @@ -0,0 +1,42 @@
> +.. SPDX-License-Identifier: GPL-2.0+
> +
> +imxrt1170-evk
> +=============
> +
> +How to use U-Boot on NXP i.MXRT1170 EVK
> +---------------------------------------
> +
> +- Build U-Boot for i.MXRT1170 EVK:
> +
> +.. code-block:: bash
> +
> +   $ make mrproper
> +   $ make imxrt1170-evk_defconfig
> +   $ make
> +
> +This will generate the SPL image called SPL and the u-boot.img.
> +
> +- Flash the SPL image into the micro SD card:
> +
> +.. code-block:: bash
> +
> +   $sudo dd if=SPL of=/dev/sdX bs=1k seek=1 conv=notrunc; sync
> +
> +- Flash the u-boot.img image into the micro SD card:
> +
> +.. code-block:: bash
> +
> +   $sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=128 conv=notrunc; sync
> +
> +- Jumper settings::
> +
> +   SW1: 1 0 1 0
> +   SW2: 0 0 0 0  0 0 0 0  1 0 0 0
> +
> +where 0 means bottom position and 1 means top position (from the
> +switch label numbers reference).
> +
> +- Connect the USB cable between the EVK and the PC for the console.
> +  The USB console connector is the one close the ethernet connector
> +
> +- Insert the micro SD card in the board, power it up and U-Boot messages should come up.



More information about the U-Boot mailing list