[PATCH v2] usb: ehci-mx6: Add i.MX93 support

[Mathieu Othacehe]

i.MX93 uses the same USB IP as i.MX8MM. It can then reuse the ehci-mx6
driver.

Reviewed-by: Marek Vasut <marex at denx.de>
Signed-off-by: Mathieu Othacehe <othacehe at gnu.org>
---
 drivers/usb/host/Kconfig    | 6 +++---
 drivers/usb/host/ehci-mx6.c | 2 +-
 2 files changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index 0dd5736433c..f96027d7bd2 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -210,10 +210,10 @@ config USB_EHCI_MX6
 
 config USB_EHCI_MX7
 	bool "Support for i.MX7 on-chip EHCI USB controller"
-	depends on ARCH_MX7 || IMX8M
+	depends on ARCH_MX7 || IMX8M || IMX93
 	select EHCI_HCD_INIT_AFTER_RESET if ARCH_MX7
-	select PHY if IMX8M
-	select NOP_PHY if IMX8M
+	select PHY if IMX8M || IMX93
+	select NOP_PHY if IMX8M || IMX93
 	default y
 	---help---
 	  Enables support for the on-chip EHCI controller on i.MX7 SoCs.
diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
index a9ed5e7a0d5..a35fcca43a2 100644
--- a/drivers/usb/host/ehci-mx6.c
+++ b/drivers/usb/host/ehci-mx6.c
@@ -538,7 +538,7 @@ static int ehci_usb_phy_mode(struct udevice *dev)
 			plat->init_type = USB_INIT_DEVICE;
 		else
 			plat->init_type = USB_INIT_HOST;
-	} else if (is_mx7() || is_imx8mm() || is_imx8mn()) {
+	} else if (is_mx7() || is_imx8mm() || is_imx8mn() || is_imx93()) {
 		phy_status = (void __iomem *)(addr +
 					      USBNC_PHY_STATUS_OFFSET);
 		val = readl(phy_status);
-- 
2.41.0