[PATHv11 00/43] net/lwip: add lwip library for the network stack

[Maxim Uvarov]

On Fri, 5 Jan 2024 at 02:46, Fabio Estevam <festevam at gmail.com> wrote:

> On Thu, Jan 4, 2024 at 12:02 PM Maxim Uvarov <maxim.uvarov at linaro.org>
> wrote:
>
> > CI tests this in all qemu emulated boards. I tested it locally on
> Raspberry Pi - works well. This version did not
> > yet tested on imx8, but the previous version worked on eth0, did not
> work on eth1.  So I plan to continue testing
> > these patches on different boards. But in general it's the upper layer
> then drivers and theoretically has to work on any
> > board. But in fact different boards work in different ways and behaviour
> is different with their qemu model. So I'm a little bit confused
> > how to test and debug these patches on board which I don't have physical
> access...
>
> Can you try to get access to any i.MX board via Linaro?
>


I will try, but for some reason there is no i.MX board in the lab.


>
> > that is really strange, after reboot you should get the initial stage.
> > You can type 'lwip list' and 'net list' to check if there is an IP
> address for
> > active device set.
>
> Nothing strange there:
>
> u-boot=> lwip list
> 1:  eth0 UP IP: 192.168.0.122/255.255.255.0, GW: 192.168.0.1,
> 00:04:9f:06:33:d3
> done.
> u-boot=> net list
> eth0 : ethernet at 30be0000 00:04:9f:06:12:98 active
>

MAC address is different in two commands, it has to be the same.

BR,
Maxim.