[PATCH 0/2] rockchip: Fix ethernet on Radxa ROCK Pi E v1.21

[Trevor Woerner]

Hi Jonas,

On Thu 2024-01-18 @ 07:19:44 AM, Jonas Karlman wrote:
> Ethernet on a Radxa ROCK Pi E v1.21 with a RTL8211F ethernet PHY
> currently fails with the following message:
> 
>   Could not get PHY for ethernet at ff540000: addr -1
> 
> This happens because the ethernet PHY is never reset before a phy-id is
> read back from the MDIO bus.
> 
> This series fixes this issue by calling eth_phy_set_mdio_bus() from the
> designware ethernet driver to issue a PHY reset before the phy_connect()
> call.
> 
> With the driver change and DM_ETH_PHY and PHY_REALTEK enabled the PHY
> can be identified and etherent works:
> 
>   => mdio list
>   ethernet at ff540000:
>   1 - RealTek RTL8211F <--> ethernet at ff540000
> 
> This was tested with and without the DM_MDIO option enabled. Decided to
> leave it disabled in this series.

This works great, thank you! As you suspected, both boards/PHYs work fine now
work under Linux (in addition to U-Boot).

Tested-By: Trevor Woerner <twoerner at gmail.com>

> Jonas Karlman (2):
>   net: designware: Reset eth phy before phy connect
>   rockchip: rk3328-rock-pi-e: Enable DM_ETH_PHY and PHY_REALTEK
> 
>  configs/rock-pi-e-rk3328_defconfig | 2 ++
>  drivers/net/designware.c           | 7 +++++++
>  2 files changed, 9 insertions(+)
> 
> -- 
> 2.43.0
>