[PATCH v2] mtd: nand: raw: atmel: Use ONFI ECC params if available

[Zixun LI]

When ECC parameters are not specified in DT, first try ONFI ECC parameters
before fallback to maximum strength.

It's the Linux driver behavior since the driver rewriting in f88fc12.

>From then 2 nand system refactors have been done in 6a1b66d6 and 53576c7b,
chip->ecc_strength_ds and chip->ecc_step_ds became
nanddev_get_ecc_requirements(). U-Boot didn't follow the refactor and
always use these 2 fields.

v2: Fix formatting, add upstream commit hash.

Signed-off-by: Zixun LI <zli at ogga.fr>
---
 drivers/mtd/nand/raw/atmel/nand-controller.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/mtd/nand/raw/atmel/nand-controller.c b/drivers/mtd/nand/raw/atmel/nand-controller.c
index ee4ec6da58..817fab4ca3 100644
--- a/drivers/mtd/nand/raw/atmel/nand-controller.c
+++ b/drivers/mtd/nand/raw/atmel/nand-controller.c
@@ -1029,11 +1029,15 @@ static int atmel_nand_pmecc_init(struct nand_chip *chip)
 		req.ecc.strength = ATMEL_PMECC_MAXIMIZE_ECC_STRENGTH;
 	else if (chip->ecc.strength)
 		req.ecc.strength = chip->ecc.strength;
+	else if (chip->ecc_strength_ds)
+		req.ecc.strength = chip->ecc_strength_ds;
 	else
 		req.ecc.strength = ATMEL_PMECC_MAXIMIZE_ECC_STRENGTH;
 
 	if (chip->ecc.size)
 		req.ecc.sectorsize = chip->ecc.size;
+	else if (chip->ecc_step_ds)
+		req.ecc.sectorsize = chip->ecc_step_ds;
 	else
 		req.ecc.sectorsize = ATMEL_PMECC_SECTOR_SIZE_AUTO;
 
-- 
2.45.2