[PATCH v2 2/2] doc: develop: Fix typos and wording in gdb.rst

[Alexander Dahl]

Moin,

Am Wed, Nov 20, 2024 at 06:57:17PM +0000 schrieb Lothar Rubusch:
> Fix some typos and duplicate words in gdb.rst.
> 
> Signed-off-by: Lothar Rubusch <l.rubusch at gmail.com>
> ---
>  doc/develop/gdb.rst | 10 +++++-----
>  1 file changed, 5 insertions(+), 5 deletions(-)
> 
> diff --git a/doc/develop/gdb.rst b/doc/develop/gdb.rst
> index 4e359c7f22..79510ee94d 100644
> --- a/doc/develop/gdb.rst
> +++ b/doc/develop/gdb.rst
> @@ -8,12 +8,12 @@ Using a JTAG adapter it is possible to debug a running U-Boot with GDB.
>  A common way is to connect a debug adapter to the JTAG connector of your
>  board, run a GDB server, connect GDB to the GDB server, and use GDB as usual.
>  
> -Similarly QEMU can provide a GDB server.
> +Similarly, QEMU can provide a GDB server.
>  
>  Preparing build
>  ---------------
>  
> -Building U-Boot with with reduced optimization (-Og) and without link time
> +Building U-Boot with reduced optimization (-Og) and without link time
>  optimization is recommended for easier debugging::
>  
>      CONFIG_CC_OPTIMIZE_FOR_DEBUG=y
> @@ -24,7 +24,7 @@ Otherwise build, install, and run U-Boot as usual.
>  Using OpenOCD as GDB server
>  ---------------------------
>  
> -`OpenOCD <https://openocd.org/>`_ is an open source tool supporting hardware
> +`OpenOCD <https://openocd.org/>`_ is an open-source tool supporting hardware
>  debug probes, and providing a GDB server. It is readily available in major Linux
>  distributions or you can build it from source.
>  
> @@ -144,7 +144,7 @@ riscv        gp
>  sh           r13
>  ============ ========
>  
> -On these architecture the relocation address cat be determined by
> +On these architectures the relocation address can be determined by
>  dereferencing the global data pointer stored in register, *r9* in the example:
>  
>  .. code-block:: console
> @@ -153,7 +153,7 @@ dereferencing the global data pointer stored in register, *r9* in the example:
>       $1 = 0x27f7a000
>  
>  In the GDB shell discard the previously loaded symbol file and add it once
> -again with the relocation address like this:
> +again, with the relocation address like this:
>  
>  .. code-block:: console

Acked-by: Alexander Dahl <ada at thorsis.com>

Greets
Alex