2025.01-rc2 fails to boot on VisionFive2

[Heinrich Schuchardt]

On 13.11.24 11:31, Andreas Schwab wrote:
> "Error reading cluster" is the new error.
> 
> U-Boot SPL 2025.01-rc2 (Nov 08 2024 - 07:13:26 +0000)
> DDR version: dc2e84f0.
> Trying to boot from MMC2
> 
> 
> U-Boot 2025.01-rc2 (Nov 08 2024 - 07:13:26 +0000)
> 
> CPU:   sifive,u74-mc
> Model: StarFive VisionFive 2 v1.2A
> DRAM:  4 GiB
> Core:  136 devices, 26 uclasses, devicetree: board
> WDT:   Not starting watchdog at 13070000
> MMC:   mmc at 16010000: 0, mmc at 16020000: 1
> Loading Environment from SPIFlash... SF: Detected gd25lq128 with page size 256 Bytes, erase size 4 KiB, total 16 MiB
> *** Warning - bad CRC, using default environment
> 
> StarFive EEPROM format v2
> 
> --------EEPROM INFO--------
> Vendor : StarFive Technology Co., Ltd.
> Product full SN: VF7110A1-2249-D004E000-00000408
> data version: 0x2
> PCB revision: 0xa1
> BOM revision: A
> Ethernet MAC0 address: 6c:cf:39:00:16:8d
> Ethernet MAC1 address: 6c:cf:39:00:16:8e
> --------EEPROM INFO--------
> 
> starfive_7110_pcie pcie at 2b000000: Starfive PCIe bus probed.
> starfive_7110_pcie pcie at 2c000000: Starfive PCIe bus probed.
> In:    serial at 10000000
> Out:   serial at 10000000
> Err:   serial at 10000000
> Net:   eth0: ethernet at 16030000, eth1: ethernet at 16040000
> starting USB...
> Bus xhci_pci: Register 5000420 NbrPorts 5
> Starting the controller
> USB XHCI 1.00
> scanning bus xhci_pci for devices... 2 USB Device(s) found
>         scanning usb for storage devices... 0 Storage Device(s) found
> Working FDT set to ff72ca10
> Hit any key to stop autoboot:  0
> Card did not respond to voltage select! : -110
> ** Booting bootflow '<NULL>' with efi_mgr
> Error reading cluster

This is a message from the FAT file system driver.

Which image reproduces the problem?

Did you run dosfsck on the ESP?

Best regards

Heinrich

> Loading Boot0000 'mmc 1' failed
> EFI boot manager: Cannot load any image
> Boot failed (err=-14)
> Card did not respond to voltage select! : -110
>