[PATCH v1] arch: arm: dts: agilex5: Set SDIO_SEL GPIO pin as output

[alif.zakuan.yuslaimi at altera.com]

From: Alif Zakuan Yuslaimi <alif.zakuan.yuslaimi at intel.com>

Use GPIO hogging method in device tree to set SDIO_SEL pin (portb3)
direction as output with value 0 after power-on reset.

This is to ensure stable 0V voltage reading from SDIO_SEL GPIO pin
after board init.

Signed-off-by: Alif Zakuan Yuslaimi <alif.zakuan.yuslaimi at intel.com>
---
 arch/arm/dts/socfpga_agilex5-u-boot.dtsi | 11 +++++++++++
 configs/socfpga_agilex5_defconfig        |  3 +++
 2 files changed, 14 insertions(+)

diff --git a/arch/arm/dts/socfpga_agilex5-u-boot.dtsi b/arch/arm/dts/socfpga_agilex5-u-boot.dtsi
index 8d6503dd091..b34af85c58d 100644
--- a/arch/arm/dts/socfpga_agilex5-u-boot.dtsi
+++ b/arch/arm/dts/socfpga_agilex5-u-boot.dtsi
@@ -673,6 +673,17 @@
 	bootph-all;
 };
 
+&gpio1 {
+	/* Configure GPIO 1 pin 3 as output pin with value 0 during GPIO probe */
+	portb: gpio-controller at 0{
+		sdio_sel {
+			gpio-hog;
+			gpios = <3 GPIO_ACTIVE_HIGH>;
+			output-low;
+		};
+	};
+};
+
 &i2c0 {
 	reset-names = "i2c";
 };
diff --git a/configs/socfpga_agilex5_defconfig b/configs/socfpga_agilex5_defconfig
index 8f327e5f2ab..cf0d678e1a2 100644
--- a/configs/socfpga_agilex5_defconfig
+++ b/configs/socfpga_agilex5_defconfig
@@ -1,6 +1,7 @@
 CONFIG_ARM=y
 CONFIG_ARCH_SOCFPGA=y
 CONFIG_TEXT_BASE=0x80200000
+CONFIG_SPL_GPIO=y
 CONFIG_NR_DRAM_BANKS=3
 CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
 CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x80300000
@@ -73,6 +74,8 @@ CONFIG_BOOTFILE="kernel.itb"
 CONFIG_NET_RANDOM_ETHADDR=y
 CONFIG_SPL_DM_SEQ_ALIAS=y
 CONFIG_SPL_ALTERA_SDRAM=y
+CONFIG_GPIO_HOG=y
+CONFIG_SPL_GPIO_HOG=y
 CONFIG_DWAPB_GPIO=y
 CONFIG_DM_I2C=y
 CONFIG_SYS_I2C_DW=y
-- 
2.25.1