[PATCH 4/4] qcom_defconfig: enable fastboot

[Caleb Connolly]

Enable fastboot support over USB, using MMC as the backend. This will be
the internal eMMC on devices that have it, or the sdcard slot on devices
with UFS (if available).

We don't use a fixed address for the fastboot buffer because it's
allocated at runtime per-board. Entering fastboot mode should be done by
executing "run fastboot" or manually running:

fastboot -l $fastboot_addr_r usb 0

Signed-off-by: Caleb Connolly <caleb.connolly at linaro.org>
---
 configs/qcom_defconfig | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/configs/qcom_defconfig b/configs/qcom_defconfig
index ba4d38d100e053e3708ee2623bf3530787b6b94f..f5c005d9c4093e4902b05213ab2f54c8ca70208a 100644
--- a/configs/qcom_defconfig
+++ b/configs/qcom_defconfig
@@ -61,8 +61,13 @@ CONFIG_CLK_QCOM_SC7280=y
 CONFIG_CLK_QCOM_X1E80100=y
 CONFIG_DFU_MMC=y
 CONFIG_DFU_SCSI=y
 CONFIG_SYS_DFU_DATA_BUF_SIZE=0x200000
+CONFIG_USB_FUNCTION_FASTBOOT=y
+CONFIG_FASTBOOT_BUF_ADDR=0x0
+CONFIG_FASTBOOT_FLASH=y
+CONFIG_FASTBOOT_FLASH_MMC_DEV=0
+CONFIG_FASTBOOT_MMC_USER_SUPPORT=y
 CONFIG_MSM_GPIO=y
 CONFIG_QCOM_PMIC_GPIO=y
 CONFIG_DM_I2C=y
 CONFIG_SYS_I2C_QUP=y

-- 
2.49.0