[PATCH] board: beacon: imx8mp: Fix GIC clock for Overdrive mode

Adam Ford aford173 at gmail.com
Tue Mar 25 03:02:14 CET 2025


On Mon, Mar 24, 2025 at 6:34 PM Fabio Estevam <festevam at gmail.com> wrote:
>
> Hi Adam,
>
> On Mon, Mar 24, 2025 at 8:27 PM Adam Ford <aford173 at gmail.com> wrote:
> >
> > There is a config option to run the PMIC at nominal voltages
> > which is not enabled on the i.MX8MP Beacon kit, so it the PMIC
> > runs at overdrive voltages.   Unfortuately, the check for this
> > condition to set the GIC clock parent and rate is backwards from
> > what it should be, and accidentally sets the GIC clock to nominal
> > if the PMIC is in overdrive, and sets the GIC clock to overdrive
> > if the PMIC is in nominal.  Fix this by inverting the logic on the
> > check.
> >
> > Fixes: ab53bd43dbde ("arm64: imx: Add support for imx8mp-beacon-kit")
> > Signed-off-by: Adam Ford <aford173 at gmail.com>
>
> Is this U-Boot 2025.04 material, or can it wait until 2025.07?

It's been wrong since the beginning, and I only ran into it by
accident, so it's not obvious.  It can wait until 2025.07.

thanks

adam


More information about the U-Boot mailing list