[RFC PATCH 2/5] usb: host: re-import xhci-ext-caps.h from kernel v6.16-rc7
Jerome Forissier
jerome.forissier at linaro.org
Fri Nov 21 16:37:51 CET 2025
Import drivers/usb/host/xhci-ext-caps.h from Linux v6.16-rc7. The file
is needed by the updated DWC3 code.
Signed-off-by: Jerome Forissier <jerome.forissier at linaro.org>
---
drivers/usb/host/xhci-ext-caps.h | 158 +++++++++++++++++++++++++++++++
1 file changed, 158 insertions(+)
create mode 100644 drivers/usb/host/xhci-ext-caps.h
diff --git a/drivers/usb/host/xhci-ext-caps.h b/drivers/usb/host/xhci-ext-caps.h
new file mode 100644
index 000000000000..fd23eda6f616
--- /dev/null
+++ b/drivers/usb/host/xhci-ext-caps.h
@@ -0,0 +1,158 @@
+/* SPDX-License-Identifier: GPL-2.0 */
+/* Imported from Linux v6.16-rc7 */
+/*
+ * xHCI host controller driver
+ *
+ * Copyright (C) 2008 Intel Corp.
+ *
+ * Author: Sarah Sharp
+ * Some code borrowed from the Linux EHCI driver.
+ */
+
+/* HC should halt within 16 ms, but use 32 ms as some hosts take longer */
+#define XHCI_MAX_HALT_USEC (32 * 1000)
+/* HC not running - set to 1 when run/stop bit is cleared. */
+#define XHCI_STS_HALT (1<<0)
+
+/* HCCPARAMS offset from PCI base address */
+#define XHCI_HCC_PARAMS_OFFSET 0x10
+/* HCCPARAMS contains the first extended capability pointer */
+#define XHCI_HCC_EXT_CAPS(p) (((p)>>16)&0xffff)
+
+/* Command and Status registers offset from the Operational Registers address */
+#define XHCI_CMD_OFFSET 0x00
+#define XHCI_STS_OFFSET 0x04
+
+#define XHCI_MAX_EXT_CAPS 50
+
+/* Capability Register */
+/* bits 7:0 - how long is the Capabilities register */
+#define XHCI_HC_LENGTH(p) (((p)>>00)&0x00ff)
+
+/* Extended capability register fields */
+#define XHCI_EXT_CAPS_ID(p) (((p)>>0)&0xff)
+#define XHCI_EXT_CAPS_NEXT(p) (((p)>>8)&0xff)
+#define XHCI_EXT_CAPS_VAL(p) ((p)>>16)
+/* Extended capability IDs - ID 0 reserved */
+#define XHCI_EXT_CAPS_LEGACY 1
+#define XHCI_EXT_CAPS_PROTOCOL 2
+#define XHCI_EXT_CAPS_PM 3
+#define XHCI_EXT_CAPS_VIRT 4
+#define XHCI_EXT_CAPS_ROUTE 5
+/* IDs 6-9 reserved */
+#define XHCI_EXT_CAPS_DEBUG 10
+/* Vendor caps */
+#define XHCI_EXT_CAPS_VENDOR_INTEL 192
+#define XHCI_EXT_CAPS_INTEL_SPR_SHADOW 206
+/* USB Legacy Support Capability - section 7.1.1 */
+#define XHCI_HC_BIOS_OWNED (1 << 16)
+#define XHCI_HC_OS_OWNED (1 << 24)
+
+/* USB Legacy Support Capability - section 7.1.1 */
+/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */
+#define XHCI_LEGACY_SUPPORT_OFFSET (0x00)
+
+/* USB Legacy Support Control and Status Register - section 7.1.2 */
+/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */
+#define XHCI_LEGACY_CONTROL_OFFSET (0x04)
+/* bits 1:3, 5:12, and 17:19 need to be preserved; bits 21:28 should be zero */
+#define XHCI_LEGACY_DISABLE_SMI ((0x7 << 1) + (0xff << 5) + (0x7 << 17))
+#define XHCI_LEGACY_SMI_EVENTS (0x7 << 29)
+
+/* USB 2.0 xHCI 0.96 L1C capability - section 7.2.2.1.3.2 */
+#define XHCI_L1C (1 << 16)
+
+/* USB 2.0 xHCI 1.0 hardware LMP capability - section 7.2.2.1.3.2 */
+#define XHCI_HLC (1 << 19)
+#define XHCI_BLC (1 << 20)
+
+/* Intel SPR shadow capability */
+#define XHCI_INTEL_SPR_ESS_PORT_OFFSET 0x8ac4 /* SuperSpeed port control */
+#define XHCI_INTEL_SPR_TUNEN BIT(4) /* Tunnel mode enabled */
+
+/* command register values to disable interrupts and halt the HC */
+/* start/stop HC execution - do not write unless HC is halted*/
+#define XHCI_CMD_RUN (1 << 0)
+/* Event Interrupt Enable - get irq when EINT bit is set in USBSTS register */
+#define XHCI_CMD_EIE (1 << 2)
+/* Host System Error Interrupt Enable - get irq when HSEIE bit set in USBSTS */
+#define XHCI_CMD_HSEIE (1 << 3)
+/* Enable Wrap Event - '1' means xHC generates an event when MFINDEX wraps. */
+#define XHCI_CMD_EWE (1 << 10)
+
+#define XHCI_IRQS (XHCI_CMD_EIE | XHCI_CMD_HSEIE | XHCI_CMD_EWE)
+
+/* true: Controller Not Ready to accept doorbell or op reg writes after reset */
+#define XHCI_STS_CNR (1 << 11)
+
+/**
+ * struct xhci_protocol_caps
+ * @revision: major revision, minor revision, capability ID,
+ * and next capability pointer.
+ * @name_string: Four ASCII characters to say which spec this xHC
+ * follows, typically "USB ".
+ * @port_info: Port offset, count, and protocol-defined information.
+ */
+struct xhci_protocol_caps {
+ u32 revision;
+ u32 name_string;
+ u32 port_info;
+};
+
+#define XHCI_EXT_PORT_MAJOR(x) (((x) >> 24) & 0xff)
+#define XHCI_EXT_PORT_MINOR(x) (((x) >> 16) & 0xff)
+#define XHCI_EXT_PORT_PSIC(x) (((x) >> 28) & 0x0f)
+#define XHCI_EXT_PORT_OFF(x) ((x) & 0xff)
+#define XHCI_EXT_PORT_COUNT(x) (((x) >> 8) & 0xff)
+
+#define XHCI_EXT_PORT_PSIV(x) (((x) >> 0) & 0x0f)
+#define XHCI_EXT_PORT_PSIE(x) (((x) >> 4) & 0x03)
+#define XHCI_EXT_PORT_PLT(x) (((x) >> 6) & 0x03)
+#define XHCI_EXT_PORT_PFD(x) (((x) >> 8) & 0x01)
+#define XHCI_EXT_PORT_LP(x) (((x) >> 14) & 0x03)
+#define XHCI_EXT_PORT_PSIM(x) (((x) >> 16) & 0xffff)
+
+#include <linux/io.h>
+
+/**
+ * Find the offset of the extended capabilities with capability ID id.
+ *
+ * @base PCI MMIO registers base address.
+ * @start address at which to start looking, (0 or HCC_PARAMS to start at
+ * beginning of list)
+ * @id Extended capability ID to search for, or 0 for the next
+ * capability
+ *
+ * Returns the offset of the next matching extended capability structure.
+ * Some capabilities can occur several times, e.g., the XHCI_EXT_CAPS_PROTOCOL,
+ * and this provides a way to find them all.
+ */
+
+static inline int xhci_find_next_ext_cap(void __iomem *base, u32 start, int id)
+{
+ u32 val;
+ u32 next;
+ u32 offset;
+
+ offset = start;
+ if (!start || start == XHCI_HCC_PARAMS_OFFSET) {
+ val = readl(base + XHCI_HCC_PARAMS_OFFSET);
+ if (val == ~0)
+ return 0;
+ offset = XHCI_HCC_EXT_CAPS(val) << 2;
+ if (!offset)
+ return 0;
+ }
+ do {
+ val = readl(base + offset);
+ if (val == ~0)
+ return 0;
+ if (offset != start && (id == 0 || XHCI_EXT_CAPS_ID(val) == id))
+ return offset;
+
+ next = XHCI_EXT_CAPS_NEXT(val);
+ offset += next << 2;
+ } while (next);
+
+ return 0;
+}
--
2.48.1
More information about the U-Boot
mailing list