[PATCH 3/4] arch: arm: mach-socfpga: Adjust a raw sectors for MMC loading of U-Boot from SPL

[Sune Brian]

> That's because it never used that (intentionally). We always booted from
> a partition ID, but the old versions had all methods enabled, and that
> papered over the fact that they were mangled into something that was
> supposed to use partition ID but used bits from the other paths as well
> to compensate mistakes.

Are you using the mainstream or Altera U-Boot trunk from the beginning?
Why does it sound like we are not on the same page?

It is not even allowed to select two settings since early 2025 major
changes on the detection of the boot method.

[*] Use raw reads to locate the next boot phase
                                           │ │
  │ │                                                 Method for
locating next phase of boot (e.g. U-Boot) (MMC raw mode: by partition
type)  --->                │ │
  │ │                                           (0xa2) Partition Type
on the MMC to load U-Boot from

How can you select two at a time?

>
> Just study my series to see all the breakages. It was never clean,
> though, and that may explain working setups by luck.

I am using a custom board na socfpga on Cyclone V SoC. There are
no such things about luck. Either it works or fails.

Completely lost on your case and the patch.

Brian