[PATCH 06/11] spi: airoha: reduce the number of modification of REG_SPI_NFI_CNFG and REG_SPI_NFI_SECCUS_SIZE registers

[Mikhail Kshevetskiy]

This just reduce the number of modification of REG_SPI_NFI_CNFG and
REG_SPI_NFI_SECCUS_SIZE registers during dirmap operation.

This patch is a necessary step to avoid usage of flash specific
parameters.

Signed-off-by: Mikhail Kshevetskiy <mikhail.kshevetskiy at iopsys.eu>
---
 drivers/spi/airoha_snfi_spi.c | 135 +++++++++++++++++++++++++---------
 1 file changed, 102 insertions(+), 33 deletions(-)

diff --git a/drivers/spi/airoha_snfi_spi.c b/drivers/spi/airoha_snfi_spi.c
index 71e4fc13924..55eb6d85884 100644
--- a/drivers/spi/airoha_snfi_spi.c
+++ b/drivers/spi/airoha_snfi_spi.c
@@ -641,7 +641,48 @@ static ssize_t airoha_snand_dirmap_read(struct spi_mem_dirmap_desc *desc,
 	if (err < 0)
 		return err;
 
-	err = airoha_snand_nfi_config(priv);
+	/* NFI reset */
+	err = regmap_write(priv->regmap_nfi, REG_SPI_NFI_CON,
+			   SPI_NFI_FIFO_FLUSH | SPI_NFI_RST);
+	if (err)
+		goto error_dma_mode_off;
+
+	/* NFI configure:
+	 *   - No AutoFDM (custom sector size (SECCUS) register will be used)
+	 *   - No SoC's hardware ECC (flash internal ECC will be used)
+	 *   - Use burst mode (faster, but requires 16 byte alignment for addresses)
+	 *   - Setup for reading (SPI_NFI_READ_MODE)
+	 *   - Setup reading command: FIELD_PREP(SPI_NFI_OPMODE, 6)
+	 *   - Use DMA instead of PIO for data reading
+	 */
+	err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
+				 SPI_NFI_DMA_MODE |
+				 SPI_NFI_READ_MODE |
+				 SPI_NFI_DMA_BURST_EN |
+				 SPI_NFI_HW_ECC_EN |
+				 SPI_NFI_AUTO_FDM_EN |
+				 SPI_NFI_OPMODE,
+				 SPI_NFI_DMA_MODE |
+				 SPI_NFI_READ_MODE |
+				 SPI_NFI_DMA_BURST_EN |
+				 FIELD_PREP(SPI_NFI_OPMODE, 6));
+	if (err)
+		goto error_dma_mode_off;
+
+	/* Set number of sector will be read */
+	val = FIELD_PREP(SPI_NFI_SEC_NUM, priv->nfi_cfg.sec_num);
+	err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CON,
+				 SPI_NFI_SEC_NUM, val);
+	if (err)
+		goto error_dma_mode_off;
+
+	/* Set custom sector size */
+	val = priv->nfi_cfg.sec_size;
+	err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_SECCUS_SIZE,
+				 SPI_NFI_CUS_SEC_SIZE |
+				 SPI_NFI_CUS_SEC_SIZE_EN,
+				 FIELD_PREP(SPI_NFI_CUS_SEC_SIZE, val) |
+				 SPI_NFI_CUS_SEC_SIZE_EN);
 	if (err)
 		goto error_dma_mode_off;
 
@@ -654,7 +695,14 @@ static ssize_t airoha_snand_dirmap_read(struct spi_mem_dirmap_desc *desc,
 	if (err)
 		goto error_dma_unmap;
 
-	/* set cust sec size */
+	/*
+	 * Setup transfer length
+	 * ---------------------
+	 * The following rule MUST be met:
+	 *     transfer_length =
+	 *        = NFI_SNF_MISC_CTL2.read_data_byte_number =
+	 *        = NFI_CON.sector_number * NFI_SECCUS.custom_sector_size
+	 */
 	val = priv->nfi_cfg.sec_size * priv->nfi_cfg.sec_num;
 	val = FIELD_PREP(SPI_NFI_READ_DATA_BYTE_NUM, val);
 	err = regmap_update_bits(priv->regmap_nfi,
@@ -681,18 +729,6 @@ static ssize_t airoha_snand_dirmap_read(struct spi_mem_dirmap_desc *desc,
 	if (err)
 		goto error_dma_unmap;
 
-	/* set nfi read */
-	err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-				 SPI_NFI_OPMODE,
-				 FIELD_PREP(SPI_NFI_OPMODE, 6));
-	if (err)
-		goto error_dma_unmap;
-
-	err = regmap_set_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-			      SPI_NFI_READ_MODE | SPI_NFI_DMA_MODE);
-	if (err)
-		goto error_dma_unmap;
-
 	err = regmap_write(priv->regmap_nfi, REG_SPI_NFI_CMD, 0x0);
 	if (err)
 		goto error_dma_unmap;
@@ -783,7 +819,48 @@ static ssize_t airoha_snand_dirmap_write(struct spi_mem_dirmap_desc *desc,
 	if (err < 0)
 		return err;
 
-	err = airoha_snand_nfi_config(priv);
+	/* NFI reset */
+	err = regmap_write(priv->regmap_nfi, REG_SPI_NFI_CON,
+			   SPI_NFI_FIFO_FLUSH | SPI_NFI_RST);
+	if (err)
+		goto error_dma_mode_off;
+
+	/*
+	 * NFI configure:
+	 *   - No AutoFDM (custom sector size (SECCUS) register will be used)
+	 *   - No SoC's hardware ECC (flash internal ECC will be used)
+	 *   - Use burst mode (faster, but requires 16 byte alignment for addresses)
+	 *   - Setup for writing (SPI_NFI_READ_MODE bit is cleared)
+	 *   - Setup writing command: FIELD_PREP(SPI_NFI_OPMODE, 3)
+	 *   - Use DMA instead of PIO for data writing
+	 */
+	err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
+				 SPI_NFI_DMA_MODE |
+				 SPI_NFI_READ_MODE |
+				 SPI_NFI_DMA_BURST_EN |
+				 SPI_NFI_HW_ECC_EN |
+				 SPI_NFI_AUTO_FDM_EN |
+				 SPI_NFI_OPMODE,
+				 SPI_NFI_DMA_MODE |
+				 SPI_NFI_DMA_BURST_EN |
+				 FIELD_PREP(SPI_NFI_OPMODE, 3));
+	if (err)
+		goto error_dma_mode_off;
+
+	/* Set number of sector will be written */
+	val = FIELD_PREP(SPI_NFI_SEC_NUM, priv->nfi_cfg.sec_num);
+	err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CON,
+				 SPI_NFI_SEC_NUM, val);
+	if (err)
+		goto error_dma_mode_off;
+
+	/* Set custom sector size */
+	val = priv->nfi_cfg.sec_size;
+	err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_SECCUS_SIZE,
+				 SPI_NFI_CUS_SEC_SIZE |
+				 SPI_NFI_CUS_SEC_SIZE_EN,
+				 FIELD_PREP(SPI_NFI_CUS_SEC_SIZE, val) |
+				 SPI_NFI_CUS_SEC_SIZE_EN);
 	if (err)
 		goto error_dma_mode_off;
 
@@ -796,8 +873,16 @@ static ssize_t airoha_snand_dirmap_write(struct spi_mem_dirmap_desc *desc,
 	if (err)
 		goto error_dma_unmap;
 
-	val = FIELD_PREP(SPI_NFI_PROG_LOAD_BYTE_NUM,
-			 priv->nfi_cfg.sec_size * priv->nfi_cfg.sec_num);
+	/*
+	 * Setup transfer length
+	 * ---------------------
+	 * The following rule MUST be met:
+	 *     transfer_length =
+	 *        = NFI_SNF_MISC_CTL2.write_data_byte_number =
+	 *        = NFI_CON.sector_number * NFI_SECCUS.custom_sector_size
+	 */
+	val = priv->nfi_cfg.sec_size * priv->nfi_cfg.sec_num;
+	val = FIELD_PREP(SPI_NFI_PROG_LOAD_BYTE_NUM, val);
 	err = regmap_update_bits(priv->regmap_nfi,
 				 REG_SPI_NFI_SNF_MISC_CTL2,
 				 SPI_NFI_PROG_LOAD_BYTE_NUM, val);
@@ -822,22 +907,6 @@ static ssize_t airoha_snand_dirmap_write(struct spi_mem_dirmap_desc *desc,
 	if (err)
 		goto error_dma_unmap;
 
-	err = regmap_clear_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-				SPI_NFI_READ_MODE);
-	if (err)
-		goto error_dma_unmap;
-
-	err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-				 SPI_NFI_OPMODE,
-				 FIELD_PREP(SPI_NFI_OPMODE, 3));
-	if (err)
-		goto error_dma_unmap;
-
-	err = regmap_set_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-			      SPI_NFI_DMA_MODE);
-	if (err)
-		goto error_dma_unmap;
-
 	err = regmap_write(priv->regmap_nfi, REG_SPI_NFI_CMD, 0x80);
 	if (err)
 		goto error_dma_unmap;
-- 
2.51.0