[PATCH v4 08/13] arm: mach-k3: am62a7_init: Resume on LPM exit

[Markus Schneider-Pargmann (TI.com)]

When exiting a low power mode with DDR self-refresh, we can directly
resume after DDR setup is done. Call the common function to resume.

Signed-off-by: Markus Schneider-Pargmann (TI.com) <msp at baylibre.com>
---
 arch/arm/mach-k3/am62ax/am62a7_init.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/arch/arm/mach-k3/am62ax/am62a7_init.c b/arch/arm/mach-k3/am62ax/am62a7_init.c
index 60645272c816023798cc5d6fa46a2c569143343b..4f0a8ed66179e7f7445f9c250ffb4f53f4977546 100644
--- a/arch/arm/mach-k3/am62ax/am62a7_init.c
+++ b/arch/arm/mach-k3/am62ax/am62a7_init.c
@@ -195,6 +195,15 @@ void board_init_f(ulong dummy)
 	ret = uclass_get_device(UCLASS_RAM, 0, &dev);
 	if (ret)
 		panic("DRAM init failed: %d\n", ret);
+
+	if (wkup_ctrl_is_lpm_exit()) {
+		u64 meta_data_addr;
+
+		ret = wkup_r5f_am62_lpm_meta_data_addr(&meta_data_addr);
+		if (ret)
+			panic("Failed to get LPM meta data address %d\n", ret);
+		lpm_resume_from_ddr(meta_data_addr);
+	}
 #endif
 	spl_enable_cache();
 

-- 
2.51.0