[PATCH] imx8mp_evk: Fix the ND mode VDD_SOC voltage

[Ye Li]

From: Jacky Bai <ping.bai at nxp.com>

The 'CONFIG_IS_ENBLAED' check only works when there is a
CONFIG_SPL_IMX8M_VDD_SOC_850MV config a option is defined and enabled.
So use the 'IS_ENABLED' macro instead to fix the ND mode VDD_SOC voltage.

Signed-off-by: Jacky Bai <ping.bai at nxp.com>
Signed-off-by: Ye Li <ye.li at nxp.com>
---
 board/nxp/imx8mp_evk/spl.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/board/nxp/imx8mp_evk/spl.c b/board/nxp/imx8mp_evk/spl.c
index 27cd82e745a..cd7d79b382d 100644
--- a/board/nxp/imx8mp_evk/spl.c
+++ b/board/nxp/imx8mp_evk/spl.c
@@ -65,7 +65,7 @@ int power_init_board(void)
 	 * Enable DVS control through PMIC_STBY_REQ and
 	 * set B1_ENMODE=1 (ON by PMIC_ON_REQ=H)
 	 */
-	if (CONFIG_IS_ENABLED(IMX8M_VDD_SOC_850MV))
+	if (IS_ENABLED(CONFIG_IMX8M_VDD_SOC_850MV))
 		pmic_reg_write(dev, PCA9450_BUCK1OUT_DVS0, 0x14);
 	else
 		pmic_reg_write(dev, PCA9450_BUCK1OUT_DVS0, 0x1C);
-- 
2.37.1