[PATCH] board: dhelectronics: imx: Use second Ethernet MAC also from fuse

[Christoph Niedermaier]

From: Marek Vasut <marex at nabladev.com>
Sent: Monday, March 23, 2026 6:35 PM
> On 3/20/26 11:29 AM, Christoph Niedermaier wrote:
> 
> [...]
> 
>> +int dh_imx_get_mac_from_fuse(int dev_id, unsigned char *enetaddr)
>>   {
>>       /*
>>        * If IIM fuses contain valid MAC address, use it.
>>        * The IIM MAC address fuses are NOT programmed by default.
>>        */
>> -     imx_get_mac_from_fuse(0, enetaddr);
>> +     imx_get_mac_from_fuse(dev_id, enetaddr);
> dh_stm32 uses the second parameter as the ID, so let's be consistent here.

I'll change the parameters in the next version


Regards
Christoph

DH electronics GmbH
_____________________________________________________________________________
Am Anger 8 | 83346 Bergen | Germany | www.dh-electronics.com | Tel: +49 8662 4882 42
Board of Management: Stefan Daxenberger, Helmut Henschke | HRB Traunstein 9602